FM100 Maintenance & Operations Manual - TECO-Westinghouse ...

Fn_84:xxx0:xxx1:xx0x:xx1x:xx1x:Sequence ControlProcess Timer disabledProcess Timer enabledSet Frequency Output after Process Timer ends countZero Speed Output after Process Timer ends countProcess Sequence Auto RepeatSP1 SP2 SP3 Frequency outputOFF OFF OFF Set by external signal orDigital operator control ON OFF OFF Frequency of Fn_17 OFF ON OFF Frequency of Fn_18 ON ON OFF Frequency of Fn_19 OFF OFF ON Frequency of Fn_20 ON OFF ON Frequency of Fn_21 OFF ON ON Frequency of Fn_22 ON ON ON Frequency of Fn_23 FrequencyOutput (HZ)FWD or REVCommandSP1 Terminal 6SP2 Terminal 7SP3 Terminal 8 timeNote:If (Fn_84) is set to (xxx1) and (Fn_56) (Fn_57) and (Fn_58) are set to (0) (1) or (2) when thecontact pulse is closed on one of the designated terminals the drive will run for the programmedamount of time set in (Fn_85) through (Fn_91) and at a the programmed frequency set in (Fn_17)through (Fn_23). At the end of the sequence if there is no other command, the Inverter will resumeits frequency command by the Keypad, Remote Speed Pot, or back to (Fn_84).FrequencyOutput (HZ)OperationtimeFWD or REVCommand timeFor Process SequenceControl, use the ProcessTimers and the Preset SpeedSP1 Terminal 6functions.SP2 Terminal 7Pulse signal(Fn_85) Through (Fn_91)SP3 Terminal 8(Fn_17) Through (Fn_23)Note:When (Fn_84) is set to (xxx0), the Inverter will operated under the Multi-Speed Frequency when(Fn_56) (Fn_57) and Fn_58) are set to (0) (1) or (2).48