Red Giant Grain Stir-Ator - David Manufacturing Co.

4. Installation Procedures25. Take the gear motor power cord (14/3), hold it up to the fuse holder box and cut the cord length to fitup to the fuse holder box as shown in Figure 4AB. Connect the 14/3 cord to the box using the1/2" MPT cord connector in the bottom of the box. Route the wire from the gear motor into thefuse holder box through the cord connector on the left side of the box as shown in Figure 4AB.Connect the black and white wires of the power cord to the electronic tilt switch power-in cord andconnect the black and white wires of the gear motor wire to the electronic tilt switch power-out cord.See Figure 4AC for electronic tilt switch power-in and power-out wire locations. Connect thegreen wires of the power cord and the gear motor wire together (ground). See the wiring diagramson Pages 74-78 and see also Page 72.Figure 4ABAccelerometerlead wirePower-out wireBin wallPower connectorPower-in wireFigure 4AC Electronic controller enclosure assembly power wire routing.PNEG-1358 Red Giant Grain Stir-Ator 27