Installation Manual - GTO/Pro

9. Installation OverviewPull-To-Open Gates (Gate Opens into the Property)The diagram shown below is an example of a Pull-To-Open installation on a chain link fence and dualgate. Mounting the operators on masonry columns requires special procedures; see Column InstallationInformation on page 27. Furthermore, if you have a Push–To–Open gate, see Push–to–Open Installationon page 25 before proceeding.ReceiverGate Swings Evenly and FreelyHung Firmly and PlumbControl Box with Battery120 Volt IndoorTransformerPost Bracket AssemblyMASTER Gate OpenerSECOND Gate Opener(surge protectornot supplied)Gate Bracket6' Power CableClosed Position Stop PlatesRun 1000' (max.) of lowvoltage wire to controlbox from transformer(wire not included).PVC conduit (not included)to protect second openerpower cable and low voltage wirefrom lawn mowers and weed eaters.Concrete PouredAround Gate PostInstall the Master Gate Operator (3000XLS)Install the Post Bracket AssemblyThe post bracket is designed to work on a flat post. Postsmust be at least 6” square in order to bolt the post bracket.When using bolts to mount the post bracket, the bolts mustcompletely penetrate the post.• The best method of attaching the post bracket to ametal post is welding.• If your post exceeds 8”, it will be necessary to use hexhead bolts longer than those supplied.• Round wood posts (no smaller than 8” diameter) maybe notched to create a flat surface for attaching thepost bracket.• Wood posts will require a metal plate (not provided)between the nuts and post to prevent the operatorfrom pulling the bolts and washers through the wood.• A post smaller than 6” in diameter should be madeof metal instead of wood so that it will remain stablewhile the operator is moving the gate.• Masonry columns will require masonry anchors/hardware (not provided).GTO 3000XLS/3200XLS Instruction Manual © 01.10.12 7