Installation Manual - GTO/Pro

Generation 3 Visual FeedbackSYMPTOM DIAGNOSIS CHECK:Status (clear)1 blink Cycle TerminalShorted• Disconnect the push button, keypad, intercom keypad, orany other accessory wired to this terminal.• Try the remote. If the remote works, then the problem isthe accessory.Status (clear) 2blinksStatus (clear) 3blinksStatus (clear) 4blinksStatus (clear) 5blinksStatus (clear) 6blinksRF (yellow) FlickersRF (yellow)OFFPower (green)ONSafety TerminalShortedExit TerminalShortedShadow TerminalShortedClose EdgeTerminal ShortedOpen EdgeTerminal ShortedReceiving 318 MHzRFNo 318 MHz RFReceivedAC or Solar PowerPresent• Disconnect the loop detector, photo beam, or any otheraccessory wired to this terminal.• Try the remote. If the remote works, the problem is theaccessory.• Disconnect exit wand, loop detector, photo beam, or anyother accessory wired to this terminal.• Try remote. If the remote works, the problem is theaccessory.• Disconnect the loop detector, photo beam, or any otheraccessory wired to this terminal.• Try remote. If the remote works, the problem is theaccessory.• Disconnect the edge sensor, photo beam, or any otheraccessory wired to this terminal.• Try the remote. If the remote works, the problem is theaccessory.• Disconnect edge sensor, photo beam, or any otheraccessory wired to this terminal.• Try the remote. If the remote works, the problem is theaccessory.• Normal operation when remote or wireless keypad is used.• Battery in Remote• Program Remote• Antenna Receiver Connections• Antenna Receiver• Normal OperationVOLTAGE READINGS18 Vac Transformer 18.0 to 22.0 Vac10 W Solar panel (single) 18.0 to 22.0 VdcIn FULL SUN — measure voltage with the Solar Panel Disconnected.12 V, 7 amp hour Battery 12.5 to 13.5 Vdcor Two 12V, 7 amp hour Batteries if using solar powerMeasure voltage at battery terminals with battery disconnectedCharging circuit12.0 to 14.8 VdcMeasure voltage at battery terminals with battery connectedGTO 3000XLS/3200XLS Instruction Manual © 01.10.12 29