PowerLogic ION7550 / ION7650 User Guide - Schneider Electric

More documents

Recommendations

Info

CAUTIONObserve the following instructions, or permanent damage to the meter may occur.The ION7550 / ION7650 meter offers a range of hardware options that affectinput ratings. The ION7550 / ION7650 meter’s serial number label lists allequipped options. Applying current levels incompatible with the current inputswill permanently damage the meter. This document provides installationinstructions applicable to each hardware option.The ION7550 / ION7650 meter’s chassis ground must be properly connected tothe switchgear earth ground for the noise and surge protection circuitry tofunction correctly. Failure to do so will void the warranty.Terminal screw torque: Barrier‐type (current, voltage, and relay terminal screws:1.35 Nm (1.00 ft‐lbf) max. Captured‐wire type (digital inputs/outputs,communications, power supply: 0.90 Nm (0.66 ft.lbf) max.FCC NoticeThis equipment has been tested and found to comply with the limits for a Class Adigital device, pursuant to Part 15 of the FCC Rules. These limits are designed toprovide reasonable protection against harmful interference when the equipment isoperated in a commercial environment. This equipment generates, uses, and canradiate radio frequency energy and, if not installed and used in accordance withthe instruction manual, may cause harmful interference to radio communications.Operation of this equipment in a residential area is likely to cause harmfulinterference in which case the user will be required to correct the interference at hisown expense. The Ringer Equivalence Number (REN) for the ION7550 / ION7650optional internal modem is 0.6. Connection to the ION7550 / ION7650 internalmodem should be made via an FCC Part 68 compliant telephone cord (notsupplied). The ION7550 / ION7650 cannot be used on a public coin phone serviceor party line services.Network Compatibility Notice for the Internal ModemThe internal modem in meters equipped with this option is compatible with thetelephone systems of most countries in the world, with the exception of Australiaand New Zealand. Use in some countries may require modification of the internalmodem’s initialization strings. If problems using the modem on your phonesystem occur, please contact Schneider Electric Technical SupportStandards ComplianceCSA: Certified to CAN/CSA C22.2 No.1010-1Certified toUL 3111Made by Power Measurement Ltd.
PowerLogic, ION, ION Enterprise, MeterM@il, WebMeter and Modbus are eithertrademarks or registered trademarks of Schneider Electric. All other trademarksare property of their respective owners.Covered by one or more of the following patents:U.S. Patent Noʹs 7010438, 7006934, 6990395, 6988182, 6988025, 6983211, 6961641,6957158, 6944555, 6871150, 6853978, 6825776, 6813571, 6798191, 6798190, 6792364,6792337, 6751562, 6745138, 6737855, 6694270, 6687627, 6671654, 6671635, 6615147,6611922, 6611773, 6563697, 6493644, 6397155, 6236949, 6186842, 6185508, 6000034,5995911, 5828576, 5736847, 5650936, D505087, D459259, D458863, D443541,D439535, D435471, D432934, D429655, D427533.
Page 1: PowerLogic ® ION7550 / ION7650Ener
Page 7: Table of ContentsChapter 1 Introduc
Page 10 and 11: Chapter 1 - IntroductionION7550 / I
Page 22 and 23: Chapter 2 - Templates, Frameworks a
Page 28 and 29: Chapter 3 - Front PanelION7550 / IO
Page 54 and 55:
Chapter 3 - Front PanelION7550 / IO
Page 56 and 57:
Chapter 4 - Basic SetupION7550 / IO
Page 58 and 59:
Page 60 and 61:
Page 62 and 63:
Page 64 and 65:
Page 66 and 67:
Chapter 5 - SecurityION7550 / ION76
Page 68 and 69:
Page 70 and 71:
Page 72 and 73:
Page 74 and 75:
Page 76 and 77:
Page 78 and 79:
Chapter 6 - CommunicationsION7550 /
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Page 86 and 87:
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Chapter 7 - Third-party ProtocolsIO
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Page 122 and 123:
Page 124 and 125:
Page 126 and 127:
Page 128 and 129:
Chapter 8 - TimeION7550 / ION7650 U
Page 130 and 131:
Page 132 and 133:
Page 134 and 135:
Chapter 9 - DemandION7550 / ION7650
Page 136 and 137:
Chapter 9 - DemandION7550 / ION7650
Page 138 and 139:
Chapter 10 - Inputs / OutputsION755
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
Page 146 and 147:
Page 148 and 149:
Chapter 11 - Energy PulsingION7550
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Chapter 12 - Logging and TrendingIO
Page 156 and 157:
Page 158 and 159:
Page 160 and 161:
Page 162 and 163:
Page 164 and 165:
Page 166 and 167:
Page 168 and 169:
Page 170 and 171:
Chapter 13 - RevenueION7550 / ION76
Page 172 and 173:
Page 174 and 175:
Page 176 and 177:
Page 178 and 179:
Chapter 14 - Power QualityION7550 /
Page 180 and 181:
Page 182 and 183:
Page 184 and 185:
Page 186 and 187:
Page 188 and 189:
Chapter 15 - Test ModeION7550 / ION
Page 190 and 191:
Chapter 15 - Test ModeION7550 / ION
Page 192 and 193:
Chapter 16 - Meter ResetsION7550 /
Page 194 and 195:
Page 196 and 197:
Page 198 and 199:
Chapter 17 - AlertingION7550 / ION7
Page 200 and 201:
Page 202 and 203:
Page 204 and 205:
Chapter 18 - SetpointsION7550 / ION
Page 206 and 207:
Page 208 and 209:
Page 210 and 211:
Page 212 and 213:
Page 214 and 215:
Page 216 and 217:
Chapter 19 - ReportingION7550 / ION
Page 218 and 219:
Chapter 19 - ReportingION7550 / ION
Page 220 and 221:
settings 182energy demand log 160en
Page 222:
trend bar graphs 31custom 47trend d
show all

PowerLogic ION7550 / ION7650 User Guide - Schneider Electric

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?