Almost Ready To Fly 2M Electric Powered R/C Sailplane - Carrocar

ASSEMBLY / TAIL28.Remove the tail. Cut the covering away about 1/8"inside the line. Clean the line with rubbing alcoholafter you cut away the covering.31.Enlarge the exit hole at the rear of fuselage, makesure that clevis and control horn will pass throughfreely.1/8" ( 2-3mm)29.With main wing installed, make sure the stab andfin are parallel and perpendicular to the wing.When satisfied with the fit and alignment, glue inplace.32.Install the control horn on the elevator, the sameas you did on the aileron. The control horn is rightafter the pushrod exit hole of fuselage.30.Cut control horn as shown.33.Thread the clevis on the pushrod ( Long) then cuta small piece of silicone tube and slide it on theclevis. Insert the pushrod through the fuselage andsnap the clevis on the control horn.