Almost Ready To Fly 2M Electric Powered R/C Sailplane - Carrocar

NARROW BANDBATTCH.1CH.2CH.3CH.4CONTINOUS CURRENT :30A(MAX)INPUT VOLTAGE:7.2-8.4VNARROW BANDBATTCH.1CH.2CH.3CH.4ASSEMBLY / CANOPY4.Tape the other side of Velcro in the fuselage so itwill keep the battery in place.ACE R/CTR-402A4CH AM RECEIVER72 MHZNote: We use 6-cell Sanyo Battery Pack and theinitial setting is 4 1/4"(108mm)away from theM+B+STARTM-Auto CutoffSWBECB-OFFONmotor.7.2-8.4V Battery1/4" ( 108mm)447.The attached two pictures are the examples forusing ESC-50 and auto-cutoff.Canopy Installation45.Use switch plate as a template, drill holes theninstall the switch as shown.48.Locate the canopy. Cut 1.5mm(1/16") outside themolded line with curved scissors. Trial fit and trimit until it fits on the fuselage.1.5mm(1/16")46.Refer to the manual of Electronic Speed ControlUnit ( ESC-50 Shown P/N : ACE8014), link tomotor, battery and receiver.ACE R/CTR-402A4CH AM RECEIVER72 MHZ0NOFFBatt Rx SwACEESC-50Motor49.With the canopy in place on the fuselage, drillthree holes with (1.5mm)1/16" bit. One in the frontof canopy, two at both rear sides of the canopy.7.2-8.4V Battery1.5mm(1/16")