Almost Ready To Fly 2M Electric Powered R/C Sailplane - Carrocar

ASSEMBLY / SERVO & MOTOR36.Insert the pushrod through the EZ connector thensecure the horn on the servo when elevator inneutral position. Secure the pushrod with the 3mmset screw.If you have Rudder Control Surface then install therudder servo as the same procedure on theelevator servo.34.The kit comes with the rudder pushrod. You maychoose to have rudder control by cutting thevertical fin. Trim the rudder then tape it at bothside. Install the control horn and connect thefurnished pushrod (short). You will have to drill ahole at rudder pushrod exit fairing for rudderpushrod pass through.3mmMotor / Prop InstallationServo Installation37.Locate the motor mount, drill the 3mm(1/8") holesat the pre-punched mark.3mm(1/8")35.Install the EZ connector on the servo horn asshown. Install the elevator servo on the servotray.38.Trail fit the motor. When satisfied, secure themotor to the fuselage with furnished 3x5mmcountersunk screw.M3x5