86A180EF04-Escala PL3200R - Support On Line - Bull

4. Stand facing the front of the first rack and locate the right side.5. Install a standoff in the upper–left corner and lower–right corner of the first rack. Tightenthe standoffs to the side of the rack. See the following illustration for standoff placementlocations.6. Locate the second rack’s left side.7. Install a standoff in the upper–left corner and lower–right corner of the second rack.Tighten the standoffs to the side of the rack.8. Mount the lower long vertical foam strip on the secondary rack, starting at the bottomEMC trim.9. Mount the top short vertical foam strip on top of the bottom foam strip.10.Position the racks together.11.Align the bolt clearance holes on the rack to the standoff threaded holes located on theends of the standoffs.Note: You may have to adjust the leveling feet when aligning the standoffs tothe clearance holes on the rack.12.Install a bolt and washer in all four standoff hole positions, as shown in the followingillustration. Do not tighten the bolts at this time.13.After the racks are bolted together, level the racks.14.Tighten the four standoff bolts in the standoff holes.15.Place the front and back vertical EMC trim panels (part number 11P095) into position.The barrel spring clips located on the vertical trim panel snap over the upper and lowerstandoffs.16.Snap the top EMC trim panel (part number 11P1105) into position. The spring clipslocated at each end of the top trim panel snap over the vertical trim panels and lock itinto position.17.Connect the cables that go between the racks.18.If you are securing the racks to the floor, go to Appendix A. Securing the Rack on pageA-1.Installing the Escala PL 3200R1-5