86A180EF04-Escala PL3200R - Support On Line - Bull

The ESCALA PL 3200R has two power cords, one in the rear and one in the front. To routethe front power cord, do the following:1. Connect the plug to the Bulk Power Assembly (BPA), and ensure that the dots arealigned on the plug and receptacle.2. Secure the power cord in the channel, with the brackets from top to bottom.3. Loosen the screw on the brackets in the track on the left side. Remove the UEPO switch,and route the power cord behind the UEPO switch.4. Remove the lower panel of the frame, and route the cord through the channel under theframe.5. Route the front power cord underneath the frame to the front floor tile hole. For moreinformation about floor cutouts, refer to the Site and Hardware Planning Information,order number SA38–0508.6. Replace the lower panel of the frame.7. Replace the UEPO switch on the front of the system.To route the rear power cord, do the following:1. Connect the plug to the Bulk Power Assembly (BPA), and ensure that the dots arealigned on the plug and receptacle.2. Secure the power cord in the channel with the brackets from top to bottom.3. Remove the lower panel of the frame, and route the cord through the channel under theframe.4. Route the rear power cord underneath the frame to the back floor tile hole. For moreinformation about floor cutouts, refer to the Site and Hardware Planning Information,order number SA38–0508.5. Replace the lower panel of the frame.Installing the Escala PL 3200R1-13