EDIsecureR Instruction Manual - Intraproc GmbH

SetupInstallation and ConnectionCard Printer Connection1 Fit the card printer to the supplied unit connectionadapterInstallation LocationVentilation holes for the cooling fan are located at the rearof the laminator as well as the side and rear of the cardprinter.Allow a clearance of at least 20 cm between the sides ofthe laminator and the wall.2 Fit the laminator to the supplied unit connectionadapterAllow a clearance of at least 10 cm between the rear ofthe laminator and the wall.Card PrinterConnectionDo not place any object on the laminator.Cautions:Do not hold the rear filter cover when installing or movingthe laminator. The filter cover may be damaged ordetached from the laminator, causing the laminator to falloff and resulting in injuries.Make sure that you connect the units on a flat and firmsurface.Insert the unit connection adapter firmly into the cardprinter connection. Cards cannot be fed if there is adifference in level.After installation, if you need to remove the laminator fromthe card printer, turn off the power of the card printer.11