EDIsecureR Instruction Manual - Intraproc GmbH

More documents

Recommendations

Info

MaintenanceInterior of Laminator3 Remove any slack in the laminate film Turn the knob on the film cassette in the directionindicated by the arrow.Dirt during card feed or burrs caused by friction betweenthe bobbin holder and bobbin may adhere to the card orfilm, causing lamination defects as a result.Cautions:Start work after ensuring that the power has been turnedoff.If the security lock of the card printer is on, deactivate it.After work is complete, activate the security lock again.For details on locking/unlocking the security lock, refer tothe manual of the card printer.Stand the film cassette on a flat surface. Avoid doing soon a floor as dust attached to the film may cause pooradhesion or malfunction.A film cassette that has laminate film attached on it isheavy. Hold the film cassette with both hands to avoiddropping when working with it.4 Press and hold down the cassette button, and pullout the film cassette1 Open the laminator door2 Remove the dummy cover Press down the top of the triangle mark to remove thedummy cover.5 Apply alcohol to a cotton swab (large), and use it towipe the bobbin holder (x2)(Cotton swab and alcohol: sold separately)Bobbin holder26
6 Apply alcohol to a cotton swab (large), and use it towipe the guide rail (x2) at the back9 Remove any slack in the laminate filmCautions:Do not touch the sensor and other parts inside thelaminator. Doing so may cause the unit to malfunction.10 Insert the film cassette all the way in along theguide rail until a “click” sound is heard, and closethe laminator door7 Apply alcohol to a cotton swab (small), and use itto wipe the guide rail (x2) in frontCautions: Make sure to insert the film cassette all the way in untila “click” sound is heard. Failure to do so may result indefective patch or card jam.8 Install the dummy cover27
Page 2 and 3: Before UseCharacteristics of this U
Page 4: Before UseSafety Precautions
Page 7 and 8: Name and Functions ofPartsFrontABRe
Page 9 and 10: Internal MechanismDiagramONMLKABCDE
Page 11 and 12: SetupInstallation and ConnectionCar
Page 13 and 14: 3 Attach the tip of the new laminat
Page 15 and 16: Laminator Status, LED Display and C
Page 17 and 18: InitializingTurning On the PowerPer
Page 19 and 20: ReplacementLaminate Film3 Press and
Page 21 and 22: MaintenanceFilm residue and dust ma
Page 23 and 24: 5 Peel off the backing paper from t
Page 25: Film Cassette3 Press and hold down
Page 29 and 30: 7 Attach the jog dial to the jog di
Page 31 and 32: -13 Attach the unused portion at th
Page 33 and 34: List of Error Codes LED displays an
Page 36: Digital Identification Solutions AG

EDIsecureR Instruction Manual - Intraproc GmbH

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?