RayClic Unpowered Installation Instructions - California Detection ...

More documents

Recommendations

Info

2RayClic-S, RayClic-T, RayClic-X Installation InstructionsIf you experience difficulty during installation, refer to the “Troubleshooting Guide” on page 7.Drip loopsFor pipe-mounted applications followsteps 1 through 10 (pages 2–4).For roof-mounted applications,follow steps 2 through 9 (pages 2–4),then turn to “Roof Installation” on page 5.Splice, Tee, and Cross Installation12• Place kit on pipe and attach with plastic cable ties.• Allow enough extra heating cable to make service loops as required.• Make sure end of heating cable is cut clean.34Do not cut throughmetal braid or innerjacket.• Score around and down the outer jacket of the heating cable3 1/8-inches from the end.• Remove the outer jacket.• Place metal clip over the base of exposed braid.3 1 /8"
RayClic-S, RayClic-T, RayClic-X Installation Instructions3IceStop and XL-TraceHWAT5AHWAT Only5BIceStop and XL-Trace Only1"• Using wire cutters, cut away 1-inch of the braid.• Pull exposed braid back over metal clip.• Pull exposed braid back over metal clip.• Using wire cutters, cut away aluminum wrap.6• Insert prepared heating cableend into connector. Push until heatingcable is fully inserted and end is visiblethrough opening in connection cover plate.
Page 1: RayClic Connection SystemRayClic-S
Page 5 and 6: RayClic-S, RayClic-T, RayClic-X Ins
Page 7 and 8: RayClic-S, RayClic-T, RayClic-X Ins

RayClic Unpowered Installation Instructions - California Detection ...

Create successful ePaper yourself

Delete template?

Save as template?