RayClic Unpowered Installation Instructions - California Detection ...

More documents

Recommendations

Info

6RayClic-S, RayClic-T, RayClic-X Installation InstructionsEnd Seal Installation121"1"• Score around and down outerjacket 1-inch from the end.• Remove the outer jacket.• Do not cut or damage inner jacket.• Remove exposed braid.HWATIceStop and XL-Trace2A• Using wire cutters, cut away aluminum wrapclose to braid and outer jacket.3• Push end seal completely onto heating cable.Note: The end seal is designed to beinstalled only once; it cannot be removed from theheating cable once installed. Do not use until readyfor final installation.
RayClic-S, RayClic-T, RayClic-X Installation Instructions7Troubleshooting GuideProblemBraid clips are missing.Mounting bracket is missing.Connector does not snap onto bracket.Heating cable type not mentioned.Braid clip does not fit.Heating cable does not havealuminum wrap.Heating cable cannot beinserted into connector.Lid does not close.Heating cable cannot beinserted into end seal.Heating cable cannot be removed.SolutionThe braid clips are attached to the cardboard packing insert under the lid. The braid clips must beused to ensure a ground connection. If clips are missing or lost, call Tyco Thermal Controls at(800) 545-6258.A mounting bracket is not included in the splice, tee and cross kits. One can be ordered using one ofthe catalog numbers listed under “Optional Accessories” on the front page of these instructions whenyou place your order.The bracket has two sets of attachment clips. Fold up the four outer clips for the splice kit. Fold uponly the center clips for the tee and cross kits.RayClic components are approved for use only with Raychem HWAT, XL-Trace, and IceStop heatingcables. Do not use with other heating cables.Be sure the clip is installed on the metal braid, not on the outer jacket.Only HWAT heating cables have the aluminum wrap under the braid. Skip the aluminum wrapremoval step for XL-Trace and IceStop heating cables.Check for the following:• Outer jacket strip length is 3 1/8-inches.• Braid clip is installed on top of the metal braid, not on the outer jacket.• Braid is pulled back over braid clip.• For HWAT, 1-inch of braid is removed.• Sealing nut is loose (but not removed).• Connection screws are loose.Be sure all screws are fully tightened before closing the lid.The outer jacket must be removed from the heating cable before the end seal is installed (see the“End Seal Installation” instructions on page 6). Make sure 1-inch of outer jacket, braid, and aluminumwrap (HWAT only) are removed.The connection and end seal are designed to be installed only once; the heating cable cannot be removedonce installed. Additional RayClic-E end seals can be ordered from Tyco Thermal Controls.
Page 1 and 2: RayClic Connection SystemRayClic-S
Page 3 and 4: RayClic-S, RayClic-T, RayClic-X Ins
Page 5: RayClic-S, RayClic-T, RayClic-X Ins

RayClic Unpowered Installation Instructions - California Detection ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?