Rexnord-Stephan S4 Catalogue

04-2007 3P0200-XX7. Technical AppendixThe shrink-fit ring supplied by Rexnord-Stephan is ready for installation.Do not pull apart before initial assembly.Assemblyl Clean and degrease contact surfaces (a) and (b).l Grease contact surface (b) - BUT ON NO ACCOUNT contact surface (a) - with "Molykote D321R" or anequivalent lubricant.l Slide the geared motor onto the driven shaft until the faces (c) and (d) are positioned opposite each other. Ifnecessary, fit a threaded rod (9), nut (10) and a thrust washer (11).l Remove tools (9, 10, 11).To prevent the shaft slipping, the screws must be tightened to the torque specified in the table below in order to beable to transmit the output torque specified on the type identification plate.MountinglllInstall shrink-fit ring. Remove the spacer rings fitted between the outer rings (o) for transportation purposes.IMPORTANT: The two outer rings (o) must be arranged plane-parallel during the assembly procedure andwhile tightening the screws.Use a torque wrench to tighten the screws (8) in stages one after the other until the specified tightening torqueTA (see table) is reached. Do not tighten the screws crosswise.Fit protective cover.Size TA (Nm)1 122 123 124 125 306 357 598 1209 250CAUTION!The screws for the shrink-fit ring must never betightened if the shrink-fit ring is not fitted.T60