Ascot Owner's Manual - Pine Tree Stove Shoppe

10. Apply a bead of Mill-Pac Black sealant tothe top section of the Ø4” (10 cm) by 5”(12.5 cm) flue collar adaptor previouslyinstalled into the fireplace flue outlet.Slide the Ø4” (10 cm) flex vent overthe flue collar and secure with three (3)sheet metal screws evenly spaced.11. Place a bead of high temperaturesilicone on the intake collar of thefireplace, slide the Ø65⁄8” (16.25 cm)flex intake liner over the collar, securethe flex liner with three (3) sheet metalscrews evenly spaced.12. On the outside of the exterior wall,apply a bead of Mill-Pac Black sealantto the Ø4” (10 cm) pipe of the ventterminal. Slide the flex liner onto thevent terminal and secure with three (3)sheet metal screws evenly spaced.13. Place a bead of high temperaturesilicone on the intake collar of the ventterminal, slide the Ø65⁄8” (16.25 cm)flex intake liner over the collar, securethe flex liner with three (3) sheet metalscrews evenly spaced.Initial InstallationQUALIFIED INSTALLERS ONLYFlue Pipe AdaptorWall ThimbleFire StopExhaust 4" Flex PipeWire SpacersHorizontal Vent TerminationCombusion Air 6 5 /8" Flex PipeWall FramingFigure 18: Installation of Fireplace Horizontal Vent Kit.14. Attach the vent terminal to the outside of the house using four (4) wood screws provided.15. Light the appliance and ensure proper operation.OTHER APPROVED VENT PARTS:16Table 3: Approved Vent ManufacturersManufacturer Trade Name Nominal SizesAmerican Metal Products AmeriVent Direct 4” - 6 5/8”Security Chimneys International LTD Secure Vent 4” - 6 5/8”Selkirk Metalbestos Direct-Temp 4” - 6 5/8”Simpson Dura-Vent Direct Vent GS 4” - 6 5/8”The Ascot fireplace has been tested and certified for use with AMERICAN METAL PRODUCTS “AMERIVENTDIRECT”, SIMPSON DURAVENT TYPE GS PIPE FOR GAS STOVES. SECURITY CHIMNEY’S “SECURE VENTDIRECT VENT SYSTEM” and SELKIRK “DIRECT-TEMP VENT SYSTEM” kits are available for horizontal andvertical venting. When using Simpson Duravent, it is recommended that, before installation, a bead ofRTV High Temperature Silicone should be applied to each outer vent joint, and Mil-Pac to each innerjoint. When planning an installation, it will be necessary to select the proper length of vent pipe for theparticular requirements.WARNING: Do not mix parts from different vent manufacturers’ systems.