PDF - Pella.com

More documents

Recommendations

Info

The performance of any building is dependent upon the design, installation, and workmanshiparchitect, contractor or structural engineer prior to installation of Pella products.The individual (building owner, architect, contractor, installer and/or consumer) responsible for theproject must take into account local conditions, building codes, inherent component limitations,the effects of aging and weathering on building components, and other design issues relevant toeach project.The determination of the suitability of all building components for each project, as well as thedesign and installation of flashing and sealing systems, are the responsibility of the building owner,architect, contractor, installer and/or consumer.YOU WILL NEED TO SUPPLY:(Performance Upgrade & HurricaneShield) ® SmartFlash foil backed butyl window anddoor flashing tape or equivalent Window and Door Insulating FoamSealant by the Dow Chemical Company or equivalentlow pressure polyurethane window and doorInstallation Clip Option:TOOLS REQUIRED:and small flat blade)(Architect Series ® )(Designer Series ® )concrete applications1 ROUGH OPENING PREPARATION:A. Confirm the opening is plumb and level.Note: It is critical the bottom is level.
1 ROUGH OPENING PREPARATION (continued):B. Confirm the door will fit the opening.side, and in the center.Note: 1-1/2" or more of solid wood blocking isrequired around the perimeter of the opening.Fix any problems with the rough opening beforeproceeding.For Replacement Installation where nail fin is NOTbeing used, go to Step 5.Interior1BC. Apply flashing paper at the bottomrough opening. Position the top edge of the flashingpaper with the top of the sill plate. Center the flashingpaper with the opening width. Staple the flashing paperto the sill plate.Note: Sill flashing paper is not required for installationon concrete floors.D. Apply flashing paper to the sides of the roughopeninglonger than the height of the rough opening. Applyone piece to each jamb. Position the edge of theflashing paper with the inside edge of the trimmer (jackstud), and center the flashing paper with the height ofthe rough opening. Staple the flashing paper to thetrimmer.Exterior1D1CFOR DOORS USING OPTIONAL SILL PAN GO TO STEP 1I.E. Apply sill flashing tape #1.than the opening width. Apply at the bottom of the opening asNote: The tape is cut 12" longer than the width so that it willextend 6" up each side of the opening.F. Tab the sill flashing tape and fold.and press firmly to adhere it to the water resistive barrier. Apply sill flashing tape #2.In-swing doors: face of the framing.Note: The flashing tape may not fully cover the framing members.H. Attach the aluminum sill support or wood blocking to thePlace the sill support flush with the subfloor.GO TO STEP 2
Page 1: © 2011 Pella CorporationPart Numbe
Page 5 and 6: EXTERIOR SILL PAN LIP1 ROUGH OPENIN
Page 7 and 8: 3 SETTING AND FASTENING THE DOOR (c
Page 9 and 10: 3 SETTING AND FASTENING THE DOOR (c
Page 11 and 12: 5DOORREPLACEMENT IN SIDINGWITHOUT N
Page 13 and 14: 5DOOR REPLACEMENT IN SIDINGWITHOUT
Page 15 and 16: 7SEALINGTHE DOOR TO THEEXTERIOR WAL
Page 17: INTERIOR FINISHINGIf products canno

PDF - Pella.com

Create successful ePaper yourself

Delete template?

Save as template?