PDF - Pella.com

3 SETTING AND FASTENING THE DOOR (continued):K. Double Doors Only:Designer Series®: Place a dab of sealant into the center sill3L 3KProLine®: Remove the screw from the sill strike located onthe door sill, then place a dab of sealant into the sill strikeEntry Doors: Remove the two screws from the sill strike3K 3Jlocated on the door sill. Place a dab of sealant into thescrews into the hole.L. Double Doors Only: Shim between the frame and the rough opening at the head strikethe door frame.Designer Series:hole.ProLine:Entry Doors: Remove the two screws from the head strike located on the door head. InstallNote: For doors with pre-drilled installation holes in the head. If installation holes arepresent, drill 1/8" diameter pilot hole into the rough opening and install a #8 x 3" corrosionresistant screw (provided) in each hole. the screw passes through the shims and into the structuralframing.N. Check door operation. Open and close the door to check forNote: If there are any problems with the operation, check toconfirm the door frame is installed plumb, level and square.If the reveal between the door panel(s) and frame is noteven, adjustments may be made:Doors without adjustable hinges: Plastic shims locatedbehind the hinges may be removed to adjust the revealbetween the door panel and door frame. Additional hingeshims may be added if required.Note: Doors with adjustable hinges will have a (+)(-) on thedoor panel hinge leaf to indicate possible adjustments anddoors without adjustable hinges do not have adjustmentindicators.Adjustable hinges are not designed to make up for incorrectinstallation of a door frame. Before adjusting hinges, confirmthe door is installed plumb, level and square.AdjustableHingeInteriorNon-AdjustableHingeO. For Doors with adjustable hinges: The hinges can be used to move the panel side to sideby moving all hinges in the same direction or the hinges can slightly rotate the panel byAllen wrench for Designer Series doors to turn the center screw clockwise (+) to increase thespace between the hinge side of the frame and door panel. Turn the center screws counterclockwise(-) to decrease the space between the hinge side of the frame and the door panel.Note: Do not adjust the hinge with the top and bottom screws loose; this could force thehinge to adjust beyond its design capability which can cause the hinge to bind, damagethe hinge and/or pull out the screws. A 3/4 turn of the center screw provides approximately5/32" adjustment.3M3LInterior