Dual 10-Ohm SPDT Analog Switch (Rev. D)

TS5A23157www.ti.com ................................................................................................................................................................ SCDS165D–MAY 2004–REVISED MAY 2008ELECTRICAL CHARACTERISTICS FOR 5-V SUPPLYV + = 4.5 V to 5.5 V, T A = –40°C to 85°C (unless otherwise noted)PARAMETER SYMBOL TEST CONDITIONS T A V + MIN TYP (1) MAX UNITAnalog SwitchV COM ,Analog signal range 0 V + VV NO , V NC0 ≤ V NO or V NC ≤ V + , Switch ON,ON-state resistance r on Full 4.5 V 10 ΩI COM = –30 mA, See Figure 10ON-state resistanceV NO or V NC = 3.15 V, Switch ON,match between Δr on 25°C 4.5 V 0.15 ΩI COM = –30 mA, See Figure 10channelsON-state resistance 0 ≤ V NO or V NC ≤ V + , Switch ON,r on(flat) 25°C 4.5 V 4 Ωflatness I COM = –30 mA, See Figure 10NC, NO I NC(OFF) , V NC or V NO = 0 to V + , Switch OFF, 25°C –1 0.05 15.5 V µAOFF leakage current I NO(OFF) V COM = 0 to V + , See Figure 11 Full –1 1NC, NO I NC(ON) , V NC or V NO = 0 to V + , Switch ON, 25°C –0.1 0.15.5 V µAON leakage current I NO(ON) V COM = Open, See Figure 11 Full –1 1COM V NC or V NO = Open, Switch ON, 25°C –0.1 0.1I COM(ON) 5.5 V µAON leakage current V COM = 0 to V + , See Figure 11 Full –1 1Digital Inputs (IN12, IN2) (2) V +Input logic high VIH Full V× 0.7V +Input logic low VIL Full V× 0.325°C –1 0.05 1Input leakage current I IH , I IL V IN = 5.5 V or 0 5.5 V µAFull –1 1(1) T A = 25°C(2) All unused digital inputs of the device must be held at V+ or GND to ensure proper device operation. Refer to the TI application report,Implications of Slow or Floating CMOS Inputs, literature number SCBA004.Copyright © 2004–2008, Texas Instruments Incorporated Submit Documentation Feedback 3Product Folder Link(s): TS5A23157