TECHNICAL MANUAL - Sharq.biz
TECHNICAL MANUAL - Sharq.biz
TECHNICAL MANUAL - Sharq.biz
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
positioningIt is compulsory the use of the aligning clamp,for all diameters to be welded, which:• removes the jointing stresses during thefusion of material and the subsequentcooling time;• allows to revise possible off-centeringbetween the elements to be welded;• allows to recover the out-of-round of parts, ifovalized.In order to set the aligning clamp to the differentdiameters, it is necessary to insert the reducinginserts and in case adjust the internal distancebetween the movable jaws.In case of electrofusion fittings installation such as 90° and 45° elbows, suitablealigning clamps are available with adjustable joint.By using a colored pen or wax pencil sign onat least one third of the pipe circumference, incorrespondence to the ends to be welded, theinsertion depth in the electrofusion fitting. Thisoperation must be carried out also in case offittings with central stop.This mark, beyond helping the positioning ofthe fitting on the pipe, will permit the control atwelding end that there are no movements of thejointing.Insert the electrofusion fitting on the end of thefirst pipe up to the location mark.Fasten the pipe into the aligning clamp.Insert the second pipe into the fitting up to itslocation mark and fasten it into the aligningclamp.43