Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
mounting holes for the driving lights and headlights, as indicated in the bonnet<br />
moulding. Drill out these holes to Ø7mm.<br />
Unclip the backs for the driving lights and<br />
headlights (T1300 and T1311). Insert the<br />
halogen bulbs taking great care not to touch<br />
the glass as this can damage the bulb. The<br />
smaller bulbs with two pins go in to the driving<br />
lights T1311 and the larger bulbs with three<br />
pins go in to the headlights T1300.<br />
Mount the light units into the plastic retainers<br />
T1301. The light units are retained in the<br />
holders by three spring loaded clips that go over<br />
the top face of the light unit and clip behind the<br />
rear face of the plastic holder.<br />
The whole assembly then mounts into the<br />
bonnet with the spring and washer on the<br />
outside of the bonnet and a washer and<br />
thumbscrew on the inside of the bonnet. The<br />
headlights go in the top large moulding and the<br />
driving lights go on the bottom large moulding.<br />
By adjusting the thumbscrews the angle and<br />
direction of the light unit can be adjusted. On the driving light T1311 it is<br />
necessary to remove one of the three slotted retaining clips attached to the<br />
light unit to ensure the light fits the holder. This can be conveniently removed<br />
using electrical side cutters. The clip to be removed is the top clip just to the<br />
left-hand side of the centre top position.<br />
Front indicator assembly<br />
Side lights assembly<br />
Pilot drill a centre hole and then<br />
remove the centre of the mounting<br />
faces for the lights to approximately<br />
Ø44mm. Using the lights as a<br />
template, drill out the three mounting<br />
holes through the face of the light<br />
using a Ø3.5mm drill. Mount the lights<br />
using three No 8 12mm long selftapping<br />
screws from light fastener<br />
pack T1318 (A).<br />
Pilot drill a centre hole in the smallest light moulding. Using a Ø22mm hole<br />
© <strong>GTM</strong> CARS LTD. 7.1