You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
STEERING RACK AND COLUMN<br />
The <strong>Libra</strong> uses the standard Metro steering column bolted directly to the<br />
bottom of the structural dashboard. The steering column is spaced off the<br />
bottom of the dashboard using two TO618 at the top and two TO617 at the<br />
bottom. The bottom link between the two universal joints is lengthened on<br />
exchange by <strong>GTM</strong>. Once lengthened, this link bolts directly to the steering<br />
rack. The steering rack used by the <strong>Libra</strong> is a standard Metro L.H.D. steering<br />
rack, which bolts directly to the monocoque through the horizontal front panel.<br />
The steering rack is held off the monocoque by two 3mm spacers which allow<br />
for any final adjustment. Spreader plates are used under the clamping bolts<br />
inside the monocoque. In a similar manner to the Metro, two bolts and a<br />
standard Metro clamp are used at one end and are held with a special U bolt<br />
provided in the kit. The track rod ends used on the <strong>Libra</strong> are the standard<br />
Metro track rod ends and not the GTA GTi track rod ends. The track rod ends<br />
are fitted to the steering rack in the standard manner once the special steering<br />
rack extenders have been fitted to the steering rack. These extenders are<br />
screwed and lock bolted to the steering rack.<br />
THROTTLE PEDAL<br />
The throttle pedal used on the <strong>GTM</strong> <strong>Libra</strong> is specially designed for the <strong>Libra</strong>.<br />
It mounts on the side of the standard K Series Rover Metro pedal box as<br />
shown in the diagram.<br />
Throttle Pedal Assembly<br />
The throttle pedal T0704 mounts through an existing captive Ø8mm nut on the<br />
side of the standard K Series Rover Metro pedal box. Using a standard Ø8 x<br />
50mm long bolt, mount the throttle pedal to the K Series Rover Metro pedal<br />
box with two standard washers either side the throttle pedal and lock off the<br />
Ø8mm bolts on the inside of the pedal box to prevent it coming undone with a<br />
standard Ø8mm nut. Make sure that the throttle pedal runs freely and grease<br />
the bearing surfaces.<br />
Mount the throttle cableT0701 and switch bracket T0703 to the standard K<br />
Series pedal box as shown on the drawing using one Ø8 x 20mm long set bolt<br />
and Ø8mm washer. This bolt bolts through into the capped nut already on the<br />
pedal box assembly. The bracket mounts the 'throttle off' normal switch if you<br />
are using an early 1400cc GTi engine. It also forms a stop for the throttle<br />
pedal and mounts up the throttle cable. There are two holes for the throttle<br />
cable to go through and choose the one that matches the movement on your<br />
throttle body.<br />
The throttle cable T 0701 runs under the driver’s side carpet from the throttle<br />
pedal down the side of the sill and through the box section that supports the<br />
front edge of the seat runners. The cable then goes across to the corner of<br />
the floor where it meets the petrol tank moulding approximately 40mm from<br />
the side of the tank towards the centre of the car. The cable then runs under<br />
the engine up and across to the throttle body. It is extremely important that the<br />
© <strong>GTM</strong> CARS LTD. 10.7