C-13872 Instruction E44 Owner's Manual.pdf - Enviro
C-13872 Instruction E44 Owner's Manual.pdf - Enviro
C-13872 Instruction E44 Owner's Manual.pdf - Enviro
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
28<br />
Initial Installation<br />
TO TEST VALVE PRESSURES (INPUT RATES):<br />
QUALIFIED INSTALLERS ONLY<br />
The pressure taps are located on the front side of the valve (see Figure 35).<br />
1. Using a long flat bladed screwdriver, turn set screw counter-clockwise to loosen.<br />
2. Place 5 /16 in (8 mm) I.D. hose over the pressure taps.<br />
3. Check pressures using a manometer.<br />
4. When finished, remove hose and tighten set screw.<br />
Always check for gas leaks with a soap and water solution after completing the required<br />
pressure test.<br />
1<br />
NEVER USE AN OPEN FLAME FOR LEAK TESTING.<br />
2 3<br />
Figure 35: Valve Details.<br />
Item number DescrIptIon<br />
1 Pilot Adjustment<br />
Screw<br />
2 Inlet Pressure Test<br />
Point<br />
3 Outlet Pressure Test<br />
Point<br />
Table 6: Valve Details.
Change language