MI - Installer guide (5583 kb) - Elvox.com

CONFIGURING THE VIDEO DOOR ENTRY UNITGBAll the main functions of the video door entry unit seen in the “FUNCTIONS OF THE VIDEO DOOR ENTRYU-NIT” chapter are configured using the buttons on the front of the device (see fig. 4).Depending on the monitor operating status (ON or OFF) it is possible to set and program different functionsas follows:Enabling the self-start function.To enable this function you need to configure the entrance panel so it can receive a digital self-start command(typically selectable from CALL-F3, CALL-F4 or CALL-F5); to enable the self-start parameter on the entrancepanel for the desired command, see the section “PROGRAMMING THE Digibus PANEL (BASIC GUIDE)”. Afterthe entrance panel has been enabled you need to set the video door entry unit so it can send the digital selfstartcommand; this can be done both with the MONITOR OFF and with the MONITOR ON:• At the time of installation, enable button C as 2ndF (second function).• Keeping button C pressed, press button E at successive intervals (press - release - press - release).In this way the commands CALL-F3 , CALL-F4 and CALL-F5 are sent cyclically and the entrance panel selfstartson receiving the command programmed as the self-start command.If more than one video source is installed, it is helpful to run the command cycle so as to pass the picture betweenmultiple video cameras.WARNING! The self-start function can only be used if button C is set as 2ndF. Enabling ConversationPrivacy. In the Digibus system, Confidential Conversation is always enabled.23/36