SE SERIES INSTRUCTION MANUAL

Instructions manual SE series3. MECHANICAL MOUNTINGThe emission (TX) and receiving (RX) bars must be installed with therelevant sensitive surfaces turned toward each other; the connectorsmust be positioned on the same side and the distance must beincluded within the operating range of the model used (see section 9“Technical data”).Once they have been positioned, the two barsshould be aligned and parallel as much aspossible.The next step is the fine alignment, as shown insection 5 “Alignment procedures”.To mount the device, use the threaded pinssupplied; insert them into the slots on the twobars (Fig.12).The operator can use the pins and/or the rigidmounting brackets – supplied with the device –depending on the particular application and/or Fig.12the type of support on which the two bars mustbe placed (see Fig.13).Fig. 1317