864 ST Fireplace Installation Manual - Lopi

More documents

Recommendations

Info

16 Finalizing the Installation (for qualified installers only)Electrical Connection (required)• The electrical line to the grounded receptacle inside the fireplace must be installed by aqualified installer and must meet all local codes.• Make sure the household breaker is shut off prior to working on any electrical lines.• The fireplace must be properly grounded in accordance with local codes (or ANSI/NFPA 70-1987)• The electrical line must be a min. 14 gauge, and supply 120 Volts at 60 Hz (2 Amps)Caution:Label all wires prior to disconnection when servicing controls. Wiring errors can causeimproper and dangerous operation.Grounded ReceptacleLeft Side of FireplaceJunction Box AssemblyReceptacle Cover PlateGrounded 110VPower SupplyStrain ReliefTravis Industries 4071126 100-01195_000
Finalizing the Installation (for qualified installers only) 17Wall Switch or Thermostat InstallationWiring Diagram (Millivolt System)Do not connect 110-120 VAC to the gas control valve or wiring system of this fireplace. The switch mustbe installed by a qualified installer.The included wall switch may be installed following the directions below. An optional thermostatmay also be installed. It is attached to the gas control valve in the same manner.Caution:Label all wires prior to disconnection when servicing controls. Wiring errors can causeimproper and dangerous operation.ThermocoupleThermopilePiezo IgniterOn/Off Switch (on fireplace)RedBrownCopper Co-AxialWireOrangeRedWhiteSpark ElectrodePilot HoodOptional Wall Switch,Thermostat, orRemote ControlWall Switch Installation1. Attach the included wire to the gas control valve.Attach the two wires to the top andbottom posts on the gas controlvalve (orientation does not matter).2. Determine a location for the wall switch (the wire is a maximum 25' long). Route the wire throughthe grommet near the gas inlet hole (either side) to the junction box and attach following thedirections below. Set the on/off switch on the appliance to "OFF" to control the appliance withthe wall switch.aInsert the wirethrough the back ofthe mountedjunction box (yourjunction box maylook different).Expose 1/2" ofeach wire. Securethe wires to theposts on the side ofthe on/off switch(orientation doesnot matter).StandardScrewdriverFromAppliancebCarefully pack the wires into thejunction box. Attach the switchto the junction box. Attach theswitchplate to the switch.StandardScrewdriver© Travis Industries 4071126 100-01195_000
Page 1 and 2: 864 STFireplaceInstallationManualTe
Page 3 and 4: Table of Contents 3IntroductionOver
Page 5 and 6: Safety Warnings (continued):Safety
Page 7 and 8: Packing ListFinalizing the Installa
Page 9 and 10: Finalizing the Installation (for qu
Page 15: Finalizing the Installation (for qu
Page 19 and 20: Approved VentFinalizing the Install
Page 31 and 32: Facing OverviewFinalizing the Insta
Page 47 and 48: Back Left LogFinalizing the Install
Page 49 and 50: Back Left LogFinalizing the Install
Page 53 and 54: Optional Equipment (for qualified i
Page 61 and 62: Andiron InstallationOptional Equipm

864 ST Fireplace Installation Manual - Lopi

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?