864 ST Fireplace Installation Manual - Lopi

More documents

Recommendations

Info

54 Optional Equipment (for qualified installers only)4 Remove the pilot orifice following the instructions below. Replace with the propane pilotorificeaLift the pilot hoodoff the pilotcRemove the orifice and replace with the LP orifice. Screw theorifice all the way in and replace the pilot hood.assembly.Orifice Identification:LP (Propane) OrificebUse a hex wrench tounscrew the orifice.3535NG (Natural Gas) Orifice625/32" HexNOTE: when re-attaching,this pin lines up with thenotch in the pilot hood.5 Replace the firebox components. Install the logs and embers. Replace the glass.Travis Industries 4071126 100-01195_000
Optional Equipment (for qualified installers only) 556 Remove theregulator from thefront of the gascontrol valve.Replace with thepropane regulator,using the newgasket and screwsincluded with theregulator. NOTE:Leak test thisarea after theheater isinstalled, gas isconnected, andthe main burner islit.7 Make the gas lineconnection, bleedthe gas line (ifapplicable), startthe heater andthoroughly leaktestall gasconnections andthe gas controlvalve. Check thepilot (see theillustration below.Adjust ifnecessary.WARNING:When lighting or relightingthe pilot, theglass must be removed(see page 40).aRemove and discard the threescrews using a slotted screwdriverof Torx T-20.SlottedScrewdriver(or T-20 Torx)cInstall the LP regulator. Usethe screws included with theLP regulator. Tighten toapproximately 25 Lbs. torque.SlottedScrewdriver(or T-20 Torx)bRemove and discard theregulator, diaphram, springand center post.NOTE: Make sure theregulator gasket is correctlyaligned before installation.dPlace the LPlabel on the baseof the fireplacenear the gascontrol valve.To adjust the pilot flame, turn this screw (NOTE: if totallyunscrewed gas will come out of this port). Clockwiselowers the flame while counter-clockwise raises it.StandardScrewdriverThe pilot flame must contact the thermocouple andthermopile (see the illustration below). Adjust the pilot up ordown as necessary.© Travis Industries 4071126 100-01195_000
Page 1 and 2:
864 STFireplaceInstallationManualTe
Page 3 and 4: Table of Contents 3IntroductionOver
Page 5 and 6: Safety Warnings (continued):Safety
Page 7 and 8: Packing ListFinalizing the Installa
Page 9 and 10: Finalizing the Installation (for qu
Page 19 and 20: Approved VentFinalizing the Install
Page 31 and 32: Facing OverviewFinalizing the Insta
Page 47 and 48: Back Left LogFinalizing the Install
Page 49 and 50: Back Left LogFinalizing the Install
Page 53: Optional Equipment (for qualified i
Page 57 and 58: Optional Equipment (for qualified i
Page 59 and 60: Optional Equipment (for qualified i
Page 61 and 62: Andiron InstallationOptional Equipm
show all

864 ST Fireplace Installation Manual - Lopi

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?