material safety data sheet technowrap 2k ... - PT. Harimau Putih

MATERIAL SAFETY DATA SHEETTECHNOWRAP 2K RESIN PART A1. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND THECOMPANY/UNDERTAKINGPRODUCT NAME:TECHNOWRAP 2K TMPART NO:APPLICATIONS:SUPPLIER:WALKER TECHNICAL RESOURCES LTDTEL: +44 (0) 1224 822822FAX: +44 (0) 1224 822299E-MAIL:wtr@wtr.uk.comDATE ISSUED: 0601092. HAZARDS IDENTIFICATIONMay cause sensitisation by skin contact. Irritating to eyes and skin. Toxic to aquatic organisms, may cause longtermadverse effects in the aquatic environment.CLASSIFICATION:Xi;R36/38. R43. N;R51/53.3. COMPOSITION/INFORMATION ON INGREDIENTSNAME EC NO. CAS- NO. CONTENT CLASSIFICATIONEPOXY RESIN (Number 500-033-5 25068-38- 60-100% R43 XI;R36/38 N;R51/53average MW

MATERIAL SAFETY DATA SHEETTECHNOWRAP 2K RESIN PART A5. FIRE FIGHTING MEASURESEXTINGUISHING MEDIA:SPECIAL FIRE FIGHTINGPROCEDURES:SPECIFIC HAZARDS:PROTECTIVE MEASURES INFIRE:Carbon dioxide (CO2). Dry chemicals, sand, dolomite etc. Foam. DO NOT usewater if avoidable.Move container from fire area if it can be done without risk. Water spray shouldbe used to cool containers. Cool containers exposed to flames with water untilwell after the fire is out. Keep run-off water out of sewers and water sources.Dike for water control.In case of fire, toxic gases may be formed. Fire creates: Carbon monoxide (CO).Carbon dioxide (CO2).Use protective equipment appropriate for surrounding materials. Self containedbreathing apparatus and full protective clothing must be worn in case of fire.6. ACCIDENTAL RELEASE MEASURESPERSONAL PROTECTIONS:ENVIRONMENTALPRECAUTIONS:SPILL CLEAN-UP METHODS:Use protective gloves, goggles and suitable protective clothing. Avoid inhalationof vapours and contact with skin and eyes. Provide adequate ventilation. Incase of spills, beware of slippery floors and surfaces.Avoid release to the environment. Do not discharge into drains, water coursesor onto the ground. Contain spillages with sand, earth or any suitable adsorbentmaterial. The product should not be dumped in nature but collected anddelivered according to agreement with the localauthorities.Wear necessary protective equipment. Stop leak if possible without risk. Absorbin vermiculite, dry sand or earth and place into containers. Containers withcollected spillage must be properly labelled with correct contents and hazardsymbol. Runoff or release to sewer, waterway or ground is forbidden. Flush areaclean with lots of water. Be aware of potential for surfaces to become slippery.7. HANDLING AND STORAGEUSAGE PRECAUTIONS:Avoid spilling, skin and eye contact. Keep away from heat, sparks and open flame.Do not eat, drink or smoke when using the product. Avoid inhalation of vapours.STORAGE PRECAUTIONS: Store in tightly closed original container in a cool, dry well-ventilated place. 10 - 30*C Keep away from heat, sparks and open flame. Keep separate from food,feedstuffs, fertilisers and other sensitive material. Protect from light, includingdirect sunrays. Store separated from: Acids. Alkalies. Oxidising material.STORAGE CLASS:Chemical storage.W28-16

MATERIAL SAFETY DATA SHEETTECHNOWRAP 2K RESIN PART A8. EXPOSURE CONTROLS AND PERSONAL PROTECTIONPROTECTIVE EQUIPMENT:PROCESS CONDITIONS:ENGINEERING MEASURES:RESPIRATORY EQUIPMENT:HAND PROTECTION:EYE PROTECTION:HYGIENE MESURES:SKIN PROTECTION:Provide eyewash station.Provide adequate general and local exhaust ventilation.No specific recommendation made, but respiratory protection may still be requiredunder exceptional circumstances when excessive air contamination exists.Use protective gloves. The most suitable glove must be chosen in consultationwith the gloves supplier, who can inform about the breakthrough time of the glovematerial.Wear splash-proof eye goggles to prevent any possibility of eye contact.Wash at the end of each work shift and before eating, smoking and using the toilet.Wash promptly with soap & water if skin becomes contaminated. When using donot eat, drink or smoke.Wear apron or protective clothing in case of splashes.9. PHYSICAL AND CHEMICAL PROPERTIESAPPEARANCE:LiquidCOLOUR:Light (or pale) yellowODOUR:MildSOLUBILITY:Slightly soluble in water.BOILING POINT/RANGE( O C) >204VAPOUR PRESSURE: 0.01 RELATVITY DENSITY: 1.16 20FLASH POINT ( O C) 177 PH-VALUE, CONC. SOLUTION:10. STABILITY AND REACTIVITYSTABILITY:CONDITIONS TO AVOID:MATERIALS TO AVOID:HAZARDOUSDECOMPOSITION PRODUCTS:Stable under normal temperature conditions and recommended use.Avoid heat, flames and other sources of ignition.Strong acids. Strong alkalies. Strong oxidising substances.In case of fire, toxic gases may be formed. Fire creates: Carbon monoxide (CO).Carbon dioxide (CO2).W28-16

MATERIAL SAFETY DATA SHEETTECHNOWRAP 2K RESIN PART A11. TOXICOLOGICAL INFORMATIONINHALATION:INGESTION:SKIN CONTACT:EYE CONTACT:ROUTE OF ENTRY:TARGET ORGANS:MEDICAL SYMPTOMS:MEDICAL CONSIDERATIONS:Not relevant at normal room temperatures. When heated, irritating vapours may beformed.May cause discomfort if swallowed.Irritating to skin. May cause sensitisation by skin contact. May cause skinirritation/eczemaIrritating to eyes.Skin and/or eye contact.Skin. Eyes.Upper respiratory irritation. Skin irritation. Skin contact may cause: Allergic rash.Eye contact may cause: Irritation of eyes and mucous membranes. May causediscomfort if swallowed.Skin disorders and allergies. Persons with rash are directed to skin expert forexamination of allergic eczema.12. ECOLOGICAL INFORMATIONECOTOXICITY:BIOACCUMULATION:DEGRADABILITY:The product contains a substance which is toxic to aquatic organisms and whichmay cause long term adverse effects in the aquatic environment.No data available on bioaccumulation.No data available.13. DISPOSAL CONSIDERATIONSDISPOSAL METHODS:Do not allow runoff to sewer, waterway or ground. Dispose of waste and residuesin accordance with local authority requirements.14. TRANSPORT INFORMATIONLABEL (S) FOR CONVEYANCE:UK ROAD CLASS: CLASS 9PROPER SHIPPING NAME: ENVIRONMENTALLY HAZARDOUS SUBSTANCE, LIQUID, N.O.S. (EPOXYRESIN (Number averageMW

MATERIAL SAFETY DATA SHEETTECHNOWRAP 2K RESIN PART AADR PACK GROUP: III HAZARD NO: (ADR): 90ADR LABEL NO: 9 HAZCHEM CODE:: 3ZCEFIC TEC@NO: 90GM6-III RID CLASS NO: 9RID PACK GROUP: III UN NO SEA: UN3082IMDG CLASS: 9 EMS: F-A, S-FMFAG: See Guide MARINE POLLUTANT: NoUN NO AIR: UN3082 ICAO CLASS: 9AIR PACKAGE GR:III15. REGULATORY INFORMATIONdangerous substances andarticles.LABELLING:IrritantDangerous for the EnvironmentCONTAINS: CONTAINS EPOXY RESIN (NUMBER AVERAGE MW

MATERIAL SAFETY DATA SHEETTECHNOWRAP 2K RESIN PART A16. OTHER INFORMATIONREVISION DATE: 10/08/10REV. NO./REPL. SDSGENERATED:SDS No: 10521SAFETY DATA SHEET ApprovedSTATUS:R-PHRASES IN R36/38 Irritating to eyes and skin.FULL:R43 May cause sensitisation by skin contactR51/53 Toxic to aquatic organisms, may cause long-term adverse effects in the aquaticenvironment.DISCLAIMERTHIS INFORMATION RELATES ONLY TO THE SPECIFIC MATERIAL DESIGNATED AND MAY NOT BE VALID FOR SUCH MATERIAL USED IN COMBINATIONWITH ANY OTHER MATERIALS OR IN ANY PROCESS. SUCH INFORMATION IS, TO THE BEST OF THE COMPANY’S KNOWLEDGE AND BELIEF, ACCURATEAND RELIABLE AS OF THE DATE INDICATED. HOWEVER, NO WARRANTY, GUARANTEE OR REPRESENTATION IS MADE AS TO ITS ACCURACY,RELIABILITY OR COMPLETENESS. IT IS THE USER’S RESPONSIBILITY TO SATISFY HIMSELF AS TO THE SUITABILITY OF SUCH INFORMATION FOR HISOWN PARTICULAR USE.W28-16