2711P-UM001F-EN-P, PanelView Plus Terminals User Manual

More documents

Recommendations

Info

44 Installation 330 (12.97) 330 (12.97) 419 (18.46) 416 (16.37) Publication 2711P-UM001F-EN-P - March 2007 The depth dimensions are shown for: • base-configured unit (display module and logic module). • base-configured unit with communication module. PanelView Plus and PanelView Plus CE 1500 Dimensions 1500 Keypad or Keypad/Touch Terminal 1500 Touch Screen Terminal b b a a a 65 (2.55) Display to Logic Module b 93 (3.65) Display to Communication Module a 65 (2.55) Display to Logic Module b 93 (3.65) Display to Communication Module
Chapter Objectives Wiring and Safety Guidelines Power Connections This chapter covers wiring and safety guidelines, and provides procedures to: • remove and install the power terminal block. • connect dc power. • connect ac power. • reset the terminal. Chapter 3 Use publication NFPA 70E Electrical Safety Requirements for Employee Workplaces, IEC 60364 Electrical Installations in Buildings, or other applicable wiring safety requirements for the country of installation when wiring the devices. In addition to the NFPA guidelines: • connect the device and other similar electronic equipment to its own branch circuit. • protect the input power by a fuse or circuit breaker rated at no more than 15 A. • route incoming power to the device by a separate path from the communication lines. • cross power and communication lines at right angles if they must cross. Communication lines can be installed in the same conduit as low-level dc I/O lines (less than 10V). • shield and ground cables appropriately to avoid electromagnetic interference (EMI). Grounding minimizes noise from EMI and is a safety measure in electrical installations. For more information on grounding recommendations, refer to the National Electrical Code published by the National Fire Protection Association. For more information, refer to Wiring and Grounding Guidelines for PanelView Plus Devices, publication 2711P-TD001. You can locate this publication in the literature library at this website: http://literature.rockwellautomation.com. 45 Publication 2711P-UM001F-EN-P - March 2007
Page 1 and 2: PanelView Plus Terminals 400, 600,
Page 3 and 4: Summary of Changes The information
Page 5 and 6: Table of Contents Preface Objective
Page 7 and 8: Table of Contents 7 DH-485/DH+/Remo
Page 9 and 10: Objectives Intended Audience Parts
Page 11 and 12: Chapter Objectives Software Support
Page 13 and 14: Base-configured Unit with RS-232 an
Page 15 and 16: Display and Input Options Overview
Page 17 and 18: PanelView Plus 700 to 1500 Terminal
Page 19 and 20: Logic Modules and CompactFlash Over
Page 21 and 22: Programmable Function Keys (optiona
Page 23 and 24: Display Modules (700 to 1500 only)
Page 25 and 26: Backlights (700 to 1500 only) Cat.
Page 27 and 28: Communication Adapters Overview 27
Page 29 and 30: Chapter Objectives Hazardous Locati
Page 31 and 32: Table 2.2, Required Circuit Paramet
Page 33 and 34: Required Tools Installation 33 When
Page 35 and 36: Mounting Slots Installation 35 Foll
Page 37 and 38: Mount the 700 to 1500 Terminal in a
Page 39 and 40: Product Dimensions 90 3.54) Product
Page 41 and 42: 193 (7.58) 179 (7.04) 290 (11.40) 2
Page 43: 282 (11.12) 282 (11.12) 416 (16.36)
Page 47 and 48: Power Connections 47 2. Gently pry
Page 49 and 50: DC Power Connections 400 and 600 Te
Page 51 and 52: 700 to 1500 dc Terminals Functional
Page 53 and 54: Functional Earth Connection Power C
Page 55 and 56: Reset the Terminals Power Connectio
Page 57 and 58: Chapter Objectives Access Configura
Page 59 and 60: Navigation Buttons Configuration Mo
Page 61 and 62: Load an Application List of .MER ap
Page 63 and 64: Configure Communications Configurat
Page 65 and 66: Configuration Mode 65 You return to
Page 67 and 68: Configure the Controller Address Co
Page 69 and 70: Define an Ethernet IP Address Confi
Page 71 and 72: Define Name Server Addresses Config
Page 73 and 74: Remote Log Destination Configuratio
Page 75 and 76: List of files stored in CompactFlas
Page 77 and 78: Modify Display Settings Configurati
Page 79 and 80: Configure the Screen Saver Configur
Page 81 and 82: Font Linking Courier New MS Mincho
Page 83 and 84: Configure Keypad Settings for the T
Page 85 and 86: Enable or Disable the Cursor on Tou
Page 87 and 88: Configure Print Options Configurati
Page 89 and 90: Configure Startup Options Configura
Page 91 and 92: Run the Loaded Application on Start
Page 93 and 94: Start RSView ME Station Software an
Page 95 and 96:
Configure Startup Tests Configurati
Page 97 and 98:
View and Clear the System Event Log
Page 99 and 100:
Configuration Mode 99 2. Press the
Page 101 and 102:
Modify the Date, Time, or Time Zone
Page 103 and 104:
Change the Time Zone Configuration
Page 105 and 106:
Configuration Mode 105 3. Press OK.
Page 107 and 108:
Change the Short Date Format Config
Page 109 and 110:
Chapter Objectives Windows CE .NET
Page 111 and 112:
Windows CE .NET Operating System Ot
Page 113 and 114:
Start Menu and Taskbar Windows CE .
Page 115 and 116:
PanelView Plus CE Memory Windows CE
Page 117 and 118:
Control Panel Applications Windows
Page 119 and 120:
Identification and Notes Windows CE
Page 121 and 122:
4. Click OK in the title bar. Windo
Page 123 and 124:
Keyboard Windows CE .NET Operating
Page 125 and 126:
Windows CE .NET Operating System 12
Page 127 and 128:
Backlight Windows CE .NET Operating
Page 129 and 130:
Tests Windows CE .NET Operating Sys
Page 131 and 132:
System Windows CE .NET Operating Sy
Page 133 and 134:
Date/Time Windows CE .NET Operating
Page 135 and 136:
Internet Options Windows CE .NET Op
Page 137 and 138:
Chapter Objectives Required Tools P
Page 139 and 140:
Install and Replace Components 139
Page 141 and 142:
Install RAM or Internal CompactFlas
Page 143 and 144:
Page 145 and 146:
Communication Module Connector Logi
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Remove battery by lifting up the ed
Page 153 and 154:
6. Remove the sealing gasket. Insta
Page 155 and 156:
Replace the Backlight Install and R
Page 157 and 158:
Backlight b. Insert the new backlig
Page 159 and 160:
Replace the Keypad Legend Inserts I
Page 161 and 162:
Use an External CompactFlash Card I
Page 163 and 164:
Chapter Objectives Wiring and Safet
Page 165 and 166:
PanelView Plus and PanelView Plus C
Page 167 and 168:
Communication Port Isolation Termin
Page 169 and 170:
Serial Connections Base-configured
Page 171 and 172:
Computer Connections Terminal Conne
Page 173 and 174:
Cables Terminal Connections 173 The
Page 175 and 176:
DH+ Status Indicator Condition Indi
Page 177 and 178:
DH-485 Connections for 400 and 600
Page 179 and 180:
To Controller Remote I/O Connection
Page 181 and 182:
Minimum Requirements Terminal Conne
Page 183 and 184:
DeviceNet Module NAP and Redundant
Page 185 and 186:
DeviceNet Connections 2711P-RN10C D
Page 187 and 188:
DeviceNet Module (MOD) Status Indic
Page 189 and 190:
Chapter Objectives Transfer Applica
Page 191 and 192:
Terminate Connection on PanelView P
Page 193 and 194:
Upgrade Firmware 193 3. From the Fi
Page 195 and 196:
Upgrade Firmware 195 If other termi
Page 197 and 198:
2. Select Upgrade firmware on termi
Page 199 and 200:
Upgrade Firmware 199 8. From the Fi
Page 201 and 202:
Upgrade Firmware 201 Ignore this er
Page 203 and 204:
Load PanelView Plus CE Components Y
Page 205 and 206:
Chapter Objectives LED Indicators T
Page 207 and 208:
Check the Startup Messages for Erro
Page 209 and 210:
Startup Information Messages (1) (2
Page 211 and 212:
Startup Error Messages (1) (2) Trou
Page 213 and 214:
Isolate Problems with the Touch Scr
Page 215 and 216:
Isolate Problems with the Mouse Tro
Page 217 and 218:
Ethernet Connnection Troubleshoot t
Page 219 and 220:
Advanced Diagnostics for CE Termina
Page 221 and 222:
Restart in Safe Mode Troubleshoot t
Page 223 and 224:
Electrical Environmental Specificat
Page 225 and 226:
Mechanical Specifications 225 Attri
Page 227 and 228:
Device Vendor Model Compatible USB
Page 229 and 230:
Download Fonts to Terminal PanelVie
Page 231 and 232:
Available Fonts for Terminal Applic
Page 233 and 234:
Programmable Key Definitions Append
Page 235 and 236:
Security Considerations Appendix E
Page 237 and 238:
A ac power 400, 600 19 700 to 1500
Page 239 and 240:
K keyboard compatibility 227 mouse
Page 244:
Rockwell Automation Support Rockwel
show all

2711P-UM001F-EN-P, PanelView Plus Terminals User Manual

Create successful ePaper yourself

Delete template?

Save as template?