2711P-UM001F-EN-P, PanelView Plus Terminals User Manual
2711P-UM001F-EN-P, PanelView Plus Terminals User Manual
2711P-UM001F-EN-P, PanelView Plus Terminals User Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
46 Power Connections<br />
Remove and Install the<br />
Power Terminal Block<br />
Publication <strong>2711P</strong>-<strong>UM001F</strong>-<strong>EN</strong>-P - March 2007<br />
The terminals ship with the power terminal block installed. You can<br />
remove the terminal block for ease of installation, wiring, and<br />
maintenance.<br />
WARNING<br />
ATT<strong>EN</strong>TION<br />
400 and 600 <strong>Terminals</strong><br />
ATT<strong>EN</strong>TION<br />
Explosion Hazard<br />
• Substitution of components may impair suitability for hazardous<br />
locations.<br />
• Do not disconnect equipment unless power has been switched off<br />
and area is known to be nonhazardous.<br />
• Do not connect or disconnect components unless power has been<br />
switched off.<br />
• All wiring must comply with N.E.C. articles 501, 502, 503, and/or<br />
C.E.C. section 18-1J2 as appropriate.<br />
• Peripheral equipment must be suitable for the location in which it is<br />
used.<br />
Disconnect all power before installing or replacing components.<br />
Failure to disconnect power may result in electrical shock or<br />
damage to the terminal.<br />
The ac and dc terminal blocks are keyed and marked differently<br />
so be sure to follow markings. Do not force terminal blocks into<br />
connectors to prevent potential damage to terminal.<br />
Follows these steps to remove the terminal block in the <strong>PanelView</strong><br />
400 and 600 terminals.<br />
1. Insert the tip of small, flat-blade, screwdriver into the terminal<br />
block access slot.
Change language