M16 Maintenance Manual TM9-1005-319-23.pdf - CombatRifle.net

More documents

Recommendations

Info

ARMY TM 9-1005-319-23&P AIR FORCE TO 11W3-5-5-42 3-5. TROUBLESHOOTING PROCEDURES (CONT.). TROUBLESHOOTING (CONT.) MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION 15. HAMMER PIN "WALKS". Hammer pin (1) "walks" or works loose during firing or hammer pin Is very easy to push out of receiver when hammer Is Installed. Replace hammer assembly (p 3-62). 16. BOLT ASSEMBLY FAILS TO LOCK TO REAR AFTER FIRING LAST ROUND. Step 1. Broken bolt catch (1). Replace bolt catch (1) (p 3 62,. Step 2. Weak or broken bolt catch spring (2). Replace bolt catch spring (2) (p 3-62) Step 3 Restricted movement of bolt catch (1). Disassemble and clean. 3-14
Section III. MAINTENANCE PROCEDURES FOR THE M16A2 RIFLE AND M4/M4A1 CARBINES 3-6. MAJOR COMPONENTS OF M16A2 RIFLE AND M4/M4A1 CARBINES. ARMY TM 9-1005-319-23&P AIR FORCE TO 11W3-5-5-42 This task covers disassembly. INITIAL SETUP Tools (ARMY) Small Arms Repairman Tool Kit (item 3, app B) References TM 9-1005-319-10 (operator’s manual) Equipment Conditions Weapon assembled General Safety Instructions Before starting an inspection, be sure to clear the weapon Do not pull the trigger until the weapon has been cleared. Inspect the chamber and receiver to ensure no ammunition is present Do not keep live ammunition near work area. DISASSEMBLY a. Refer to operator’s manual. b. Remove magazine (1), sling (2), bolt carrier assembly (3), charging handle assembly (4), and upper receiver and barrel assembly (5), carrying handle assembly (5.1), from lower receiver and buttstock assembly (6). NOTE Solid Film Lubricant (SFL) is the only authorized touchup for the M16A2 rifle and M4/M4A1 carbines and may be used on up to one third of the exterior finish of the weapon. FOR ARMY CONUS USE ONLY AND AIR FORCE TRAINING WEAPONS ONLY: SFL may be used as touchup without limitation on the upper receiver and barrel assembly. This is to say that units which DO NOT fall under the category of Divisional Combat Units or rapid deployment type units may have up to 100 percent of the exterior surface of the upper receiver and barrel assembly protected with SFL if necessary. Change 4 3-15
Page 1 and 2:
ARMY TM 9-1005-319-23&P AIR FORCE T
Page 3 and 4:
By Order of the Secretary of the Ar
Page 5 and 6:
Remove Pages Insert Pages 4-1 and 4
Page 7 and 8:
Page 9 and 10:
ARMY TM 9-1005-319-23&P AIR FORCE 1
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
PREVENTIVE MAINTENANCE CHECKS AND S
Page 41 and 42:
PREVENTIVE MAINTENANCE CHECKS AND S
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78: 2-16. UPPER RECEIVER AND BARREL ASS
Page 79 and 80: ARMY TM 9-1005-319-23 & P AIR FORCE
Page 81 and 82: ARMY TM 9-1005-319-23&P AIR FORCE T
Page 83 and 84: c. INSPECTION ARMY TM 9-1005-319-23
Page 87 and 88: ARMY TM 9-1005-319-23 & P AIR FORCE
Page 91 and 92: ARMY TM 9 1005 319 23&P AIR FORCE T
Page 97 and 98: NOTE AIR FORCE ONLY: Only depot mai
Page 103 and 104: ARMY TM1 9 1 005 31 9 23&P AIR FORC
Page 105 and 106: ARMY TM 9 1005319-23&P AIR FORCE TO
Page 115 and 116: ARMY TM 9-1005-319-23&P AIR FORCF T
Page 117 and 118: TROUBLESHOOTING (CONT) ARMY TM 9-10
Page 127: ARMY TM 9-1005-319-23&P AIR FORCE T
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
ARMY TM 9-1005 319-23&P AIR FORCE T
Page 211 and 212:
ARMY TM 9 1005 319 23&P AIR FORCE T
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
SECTION II ARMY TM 9-1005-319-23&P
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
SECTION II TM9-1005-319-23&P (1) (2
Page 283 and 284:
SECTION II TM9-1005-319-23&P (1) (2
Page 285 and 286:
SECTION II TM9-1005-319-23&P (1) (2
Page 287 and 288:
SECTION II TM9-1005-319-23&P (1) (2
Page 289 and 290:
SECTION II TM9-1005-319-23&P (1) (2
Page 291 and 292:
SECTION II TM9-1005-319-23&P (1) (2
Page 293 and 294:
SECTION II TM9-1005-319-23&P (1) (2
Page 295 and 296:
SECTION II TM9-1005-319-23&P (1) (2
Page 297 and 298:
Section III TM9-1005-319-23&P (1) (
Page 299 and 300:
SECTION IV TM9-1005-319-23&P CROSS-
Page 301 and 302:
Page 303 and 304:
Page 305 and 306:
APPENDIX D EXPENDABLE/DURABLE SUPPL
Page 307 and 308:
EXPENDABLE/DURABLE SUPPLIES AND MAT
Page 309 and 310:
EXPENDABLE/DURABLE SUPPLIES AND MAT
Page 311 and 312:
Page 313 and 314:
Page 315 and 316:
Page 317 and 318:
Page 319 and 320:
Page 321 and 322:
Page 325:
PIN: 060514-005
show all

M16 Maintenance Manual TM9-1005-319-23.pdf - CombatRifle.net

Create successful ePaper yourself

Delete template?

Save as template?