M16 Maintenance Manual TM9-1005-319-23.pdf - CombatRifle.net

More documents

Recommendations

Info

ARMY TM 9-1005-319-23&P AIR FORCE TO 11W3-5-5-42 NOTE If the lower receiver is not disassembled, visually inspect for broken or damaged parts, and to ensure that the hammer and trigger springs are correctly installed before beginning this test. It is not necessary to disassemble the lower receiver for the sole purpose of this visual Inspection. If broken or damaged parts are found, disassemble (p 3-62) and repair as authorized. 5. Test two hammer pin holes and two trigger pin holes using not-go plug gage PN 12006472. This test may be conducted by disassembly of the lower receiver (p 3-62) or by pushing the pin far enough to disengage the end of the pin from the side of the receiver which is being tested. If the lower receiver is not disassembled and the not-go plug gage enters any hole to first shoulder (A), the lower receiver must be disassembled and all four holes must be tested again. 6. Gently insert the not-go plug gage and rotate it 180 degrees. If the not-go plug gage passes through any one of the four pin holes, the rifle is unserviceable and will be turned in for replacement. The gage must extend through the wall thickness to be unserviceable. 7. After completion of gaging operation, visually inspect hammer and trigger springs to ensure proper location of spring legs. Change 1 3-69
ARMY TM 9-1005-319-23&P AIR FORCE TO 11W3-5-5-42 3-13. LOWER RECEIVER AND BUTTSTOCK ASSEMBLY (CONT). e. REASSEMBLY 1. Assemble semiautomatic disconnector (1), burst disconnector (2), and trigger assembly (3). Install as a unit in lower receiver (4) using slave pin (5). 2. Install trigger pin (6) using drive pin punch. Push in until flush. Push out slave pin (5). M4A1 ONLY 2.1. Install trigger assembly (6.1), disconnector spring (6.2) and disconnector (6.3) into lower receiver and extension subassembly (6.4). 2.2. Install trigger pin (6.5) using drive pin punch. Push in until flush. 3-70 Change 4
Page 1 and 2:
ARMY TM 9-1005-319-23&P AIR FORCE T
Page 3 and 4:
By Order of the Secretary of the Ar
Page 5 and 6:
Remove Pages Insert Pages 4-1 and 4
Page 7 and 8:
Page 9 and 10:
ARMY TM 9-1005-319-23&P AIR FORCE 1
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
PREVENTIVE MAINTENANCE CHECKS AND S
Page 41 and 42:
PREVENTIVE MAINTENANCE CHECKS AND S
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
2-16. UPPER RECEIVER AND BARREL ASS
Page 79 and 80:
ARMY TM 9-1005-319-23 & P AIR FORCE
Page 81 and 82:
Page 83 and 84:
c. INSPECTION ARMY TM 9-1005-319-23
Page 85 and 86:
Page 87 and 88:
ARMY TM 9-1005-319-23 & P AIR FORCE
Page 89 and 90:
Page 91 and 92:
ARMY TM 9 1005 319 23&P AIR FORCE T
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
NOTE AIR FORCE ONLY: Only depot mai
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
ARMY TM1 9 1 005 31 9 23&P AIR FORC
Page 105 and 106:
ARMY TM 9 1005319-23&P AIR FORCE TO
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
ARMY TM 9-1005-319-23&P AIR FORCF T
Page 117 and 118:
TROUBLESHOOTING (CONT) ARMY TM 9-10
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Section III. MAINTENANCE PROCEDURES
Page 131 and 132:
Page 133 and 134: ARMY TM 9-1005-319-23&P AIR FORCE T
Page 183: ARMY TM 9-1005-319-23&P AIR FORCE T
Page 209 and 210: ARMY TM 9-1005 319-23&P AIR FORCE T
Page 211 and 212: ARMY TM 9 1005 319 23&P AIR FORCE T
Page 235 and 236:
Page 237 and 238:
Page 239 and 240:
Page 241 and 242:
ARMY TM 9-1005 319-23&P AIR FORCE T
Page 243 and 244:
Page 245 and 246:
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
SECTION II ARMY TM 9-1005-319-23&P
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
SECTION II TM9-1005-319-23&P (1) (2
Page 283 and 284:
SECTION II TM9-1005-319-23&P (1) (2
Page 285 and 286:
SECTION II TM9-1005-319-23&P (1) (2
Page 287 and 288:
SECTION II TM9-1005-319-23&P (1) (2
Page 289 and 290:
SECTION II TM9-1005-319-23&P (1) (2
Page 291 and 292:
SECTION II TM9-1005-319-23&P (1) (2
Page 293 and 294:
SECTION II TM9-1005-319-23&P (1) (2
Page 295 and 296:
SECTION II TM9-1005-319-23&P (1) (2
Page 297 and 298:
Section III TM9-1005-319-23&P (1) (
Page 299 and 300:
SECTION IV TM9-1005-319-23&P CROSS-
Page 301 and 302:
Page 303 and 304:
Page 305 and 306:
APPENDIX D EXPENDABLE/DURABLE SUPPL
Page 307 and 308:
EXPENDABLE/DURABLE SUPPLIES AND MAT
Page 309 and 310:
EXPENDABLE/DURABLE SUPPLIES AND MAT
Page 311 and 312:
Page 313 and 314:
Page 315 and 316:
Page 317 and 318:
Page 319 and 320:
Page 321 and 322:
Page 325:
PIN: 060514-005
show all

M16 Maintenance Manual TM9-1005-319-23.pdf - CombatRifle.net

Create successful ePaper yourself

Delete template?

Save as template?