Anritsu Site Master S332B User Guide - Mr Test Equipment
Anritsu Site Master S332B User Guide - Mr Test Equipment
Anritsu Site Master S332B User Guide - Mr Test Equipment
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ii<br />
Chapter 4 - Measurements 4-1<br />
Introduction. .................................4-1<br />
Measurement Functions ...........................4-1<br />
Power On Procedure .............................4-2<br />
Calibration Procedure ............................4-2<br />
Selecting the Frequency Range ..........................4-3<br />
Performing a Calibration .............................4-3<br />
Saving the Setup ..................................4-4<br />
Recalling a Setup ..................................4-4<br />
Saving a Display to Memory ............................4-4<br />
Recalling a Display From Memory ........................4-4<br />
SWR (Return Loss) and Cable Loss Measurement ............4-6<br />
Required <strong>Equipment</strong> ................................4-6<br />
Device-Under-<strong>Test</strong> Specification. .........................4-6<br />
Procedure ......................................4-6<br />
Selecting the Measurement Mode .........................4-6<br />
Selecting the Frequency Range ..........................4-6<br />
Performing a Calibration .............................4-7<br />
SWR or Return Loss Measurement ........................4-8<br />
Set the Amplitude Scale and Limit Line .....................4-8<br />
Setting the Markers. ................................4-9<br />
Cable Loss Measurement ..........................4-10<br />
Setting the Amplitude Scale ...........................4-10<br />
Setting the Markers ................................4-10<br />
DTF Measurement .............................4-12<br />
Required <strong>Equipment</strong> ...............................4-12<br />
Device-Under-<strong>Test</strong> Specification .........................4-12<br />
Procedure .....................................4-12<br />
Selecting the Measurement Mode ........................4-12<br />
Performing a Calibration .............................4-13<br />
DTF Measurement (Determining the Length of the Cable) ..........4-14<br />
Setting the Amplitude Scale ...........................4-14<br />
Setting the Marker ................................4-14<br />
DTF Measurement (Determining the quality of the cable.) ..........4-16<br />
Setting the Amplitude Scale ...........................4-16<br />
Setting the Markers ................................4-16<br />
Making Power Measurements .......................4-18<br />
Entering Power Monitor Mode. .........................4-18<br />
Zeroing the Power Monitor. ...........................4-18<br />
Measuring High Input Power Levels. ......................4-18<br />
Displaying Power in dBm and Watts ......................4-18<br />
Displaying Relative Power ............................4-18<br />
Making a Measurement with the Spectrum Analyzer ..........4-19<br />
Example – Measuring a 900 MHz signal. .................4-19<br />
Set the <strong>Site</strong> <strong>Master</strong> to Spectrum Analyzer mode ................4-19<br />
Set the center frequency .............................4-19<br />
Set the frequency span ..............................4-20<br />
Setting the marker. ................................4-20<br />
Set the Reference Level ..............................4-21
Change language