MobTel

More documents

Recommendations

Info

Handbook TELE-SERVICE Analogue/GSM/ISDN Pull the board out of the front case, pay attention not to disconnect or cutting the antenna. Pull the antenna out of the medal case. Pull the connector for the RS232 out. Pull the medal case out of the board (UNSGSM). Turn the medal case round, on the right side there is the SIM-Card holder RS232 SIM-Card Insert the SIM-Card with the gold-contacts facing down in the holder as shown above. The SIM-Card must use 3V-power-supply! 16 © Copyright 2006, 2007, 2008 by PI
Handbook TELE-SERVICE Analogue/GSM/ISDN Turn the medal case around and insert it again onto the board: RS232 Pay attention that all pins are connected on the top two lines correctly, after that reconnect the antenna. ATTENTION: the PIN in the middle of the antenna is very fine and could easily be broken! RS232 Reconnect after that RS232. © Copyright 2006, 2007, 2008 by PI 17
Page 1 and 2: Operating instructions english for
Page 3 and 4: Handbook TELE-SERVICE Analogue/GSM/
Page 15: Drawing from the top: Rack Front-Si
Page 25 and 26: 1.5.6.2 Modem Handbook TELE-SERVICE
Page 67 and 68:
Handbook TELE-SERVICE Analogue/GSM/
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
show all

MobTel

Create successful ePaper yourself

Delete template?

Save as template?