MobTel

More documents

Recommendations

Info

Handbook TELE-SERVICE Analogue/GSM/ISDN 1.8 Sending E-Mail To send E-Mail with the TeleService Device the following pre-cautions must met: - Operating system of TeleService is at least V1.48 - Cable-manager at least V3.23 - access on Internet by Phone-Call, Protocol PPP - accessible EMail-Server in the Internet, Authentification with AUTH-LOGIN 1.8.1 Properties in the Cable-manager SMS additionally to the Receiving/sending of SMS and DTMF-processing, the Type „SENDEN MAIL“ is usable. 50 © Copyright 2006, 2007, 2008 by PI
Handbook TELE-SERVICE Analogue/GSM/ISDN Attention: check Parameter before activation After activation the Device is trying to connect to MPI-Bus and station address. TS local station-address (should not be used twice in the MPI/Profibus!) PLC from this station-address the Flagword and Data-block is accessed for communication MW communication-flagword (the first byte is the command, the second is the state). Use even operand-addresses. DB communication-data-block. Provider 1/2/3/4 Configure the Internet-Provider to use, Protocol PPP is needed. In the data-block of the PLC the coding is DBB0. 1 B#16#00 2 B#16#01 3 B#16#02 4 B#16#03 Type use the type „MAIL“ to send E-Mails over Internet by Call and E-Mail-server Phone-number of the Internet-Provider, up to 20 Chars, eventually you need the Country-Code-Prefix (f.e.:0049) Charset use “NONE” for GSM or EMAIL © Copyright 2006, 2007, 2008 by PI 51
Page 1 and 2: Operating instructions english for
Page 3 and 4: Handbook TELE-SERVICE Analogue/GSM/
Page 15 and 16: Drawing from the top: Rack Front-Si
Page 25 and 26: 1.5.6.2 Modem Handbook TELE-SERVICE
Page 49: Handbook TELE-SERVICE Analogue/GSM/
Page 101 and 102:
Handbook TELE-SERVICE Analogue/GSM/
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
show all

MobTel

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?