MobTel

More documents

Recommendations

Info

Handbook TELE-SERVICE Analogue/GSM/ISDN - Special Chars with special Chars the “Umlaute” could be used (german special chars f.e. ÄÖÜäöüß). - GSM7BIT with Escapesequences you could use “Umlaute“ (german special chars f.e. ÄÖÜäöüß). Please, keep in mind that the protocol and the Charset must correspond. 1.7.2 Common SMS for Analogue / ISDN / GSM After configuration of the SMS-Mode with the MPI- Cablemanager Application, the connected PLC could then send or receive a SMS. A flag-word and a data-block is needed in the PLC. The Flag-word should be at an even operand-address. Ex.: FW 254 is the communication-flag-word the command is written to FY 254, there are the following values possible: Value Description 00h Last offer is done or no offer is running 01h SMS-Send is started 02h SMS-Receive is started (only TS GSM!) 10h DTMF-Receive is possible for one call, if a call was made the normal data-mode is entered again (not with TS ISDN!) 20h Disable DTMF- Receive, a normal SMS- Send/Receive is then again possible 42 © Copyright 2006, 2007, 2008 by PI
Handbook TELE-SERVICE Analogue/GSM/ISDN To start an offer the State-byte must be 00h and in the command-byte a 01h or 02h, in our example we start a SMSoffer with: L W#16#0100 T FW 254 In the TeleService the flag-word is read every 5 Seconds, and if needed the data-block (DB255). At end of the offer, the command-byte is written with 00h, in the state-byte is then the result-code. Receiving of a SMS is higher prior as sending. That means when in the flag-word is 0300h, only the receiving is started. When DTMF-Receive is active the modem is set into voicemode and remains in this mode until a call is made and gone on-hook or with the FW 254 the command 20h = DTMF Receive End the Voice-mode is exit. The status-byte must then be set to 00h ! The state-byte (FY 255) could have the following values: Value Description 00h SMS-Offer not yet detected by the TeleService 10h SMS-Offer is detected and is now running 11h The data-block is not existing or too small at the PLC 12h Type of Phone-number is wrong or phone-number is empty 13h Type of SMS-Message is wrong or SMS-Message is empty 14h Receive from PLC started, Access denied 15h Sending from PLC started, Access denied 20h The Provider-number in the data-block is not in the © Copyright 2006, 2007, 2008 by PI 43
Page 1 and 2: Operating instructions english for
Page 3 and 4: Handbook TELE-SERVICE Analogue/GSM/
Page 15 and 16: Drawing from the top: Rack Front-Si
Page 25 and 26: 1.5.6.2 Modem Handbook TELE-SERVICE
Page 41: Handbook TELE-SERVICE Analogue/GSM/
Page 93 and 94:
Handbook TELE-SERVICE Analogue/GSM/
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
show all

MobTel

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?