MobTel

More documents

Recommendations

Info

Handbook TELE-SERVICE Analogue/GSM/ISDN Network-related you could configure: The transfer-speed on the MPI-bus and the Profile which is used. The actually used Baudrate or the automatically found Baudrate is also displayed. Additionally the bus-parameters are displayed. The highest station-address in the bus (the less you use, the more performance on the MPI-bus, must be corresponding with the configuration in the PLC’s) 24 © Copyright 2006, 2007, 2008 by PI
1.5.6.2 Modem Handbook TELE-SERVICE Analogue/GSM/ISDN In this dialog you could configure the modem-related setup. The Init-String is composed out of several commands to the modem: AT start command &F use factory settings E0 echo off L1 loudness of speaker is low M1 speaker is on at connection Q0 enables result codes to the DTE V1 enables long-form (verbose) result codes &C1 DCD follows the state of the carrier S0=1 automatic connection after 1 ring © Copyright 2006, 2007, 2008 by PI 25
Page 1 and 2: Operating instructions english for
Page 3 and 4: Handbook TELE-SERVICE Analogue/GSM/
Page 15 and 16: Drawing from the top: Rack Front-Si
Page 23: Handbook TELE-SERVICE Analogue/GSM/
Page 75 and 76:
Handbook TELE-SERVICE Analogue/GSM/
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
show all

MobTel

Create successful ePaper yourself

Delete template?

Save as template?