BGP Configuration Guide - Juniper Networks

BGP Configuration Guide
24
NLRI for this session: inet-unicast
Peer supports Refresh capability (2)
Restart time configured on the peer: 120
Stale routes from peer are kept for: 300
Restart time requested by this peer: 120
NLRI that peer supports restart for: inet-unicast
NLRI that restart is negotiated for: inet-unicast
NLRI of received end-of-rib markers: inet-unicast
NLRI of all end-of-rib markers sent: inet-unicast
Peer supports 4 byte AS extension (peer-as 79)
Peer does not support Addpath
Table inet.0 Bit: 10000
RIB State: BGP restart is complete
Send state: in sync
Active prefixes: 0
Received prefixes: 0
Accepted prefixes: 0
Suppressed due to damping: 0
Advertised prefixes: 0
Last traffic (seconds): Received 28 Sent 24 Checked 47
Input messages: Total 8521 Updates 1 Refreshes 0 Octets 161943
Output messages: Total 8427 Updates 0 Refreshes 0 Octets 160176
Output Queue[0]: 0
Verifying BGP Groups
Purpose Verify that the BGP groups are configured correctly.
Action From operational mode, run the show bgp group command.
user@E> show bgp group
Group Type: External Local AS: 17
Name: external-peers Index: 0 Flags:
Holdtime: 0
Total peers: 4 Established: 4
10.10.10.2+179
10.10.10.6+54781
10.10.10.10+55012
10.21.7.2+61867
inet.0: 0/0/0/0
Groups: 1 Peers: 4 External: 4 Internal: 0 Down peers: 0 Flaps: 0
Table Tot Paths Act Paths Suppressed History Damp State Pending
inet.0 0 0 0 0 0 0
Verifying BGP Summary Information
Purpose Verify that the BGP configuration is correct.
Action From operational mode, run the show bgp summary command.
user@E> show bgp summary
Groups: 1 Peers: 4 Down peers: 0
Table Tot Paths Act Paths Suppressed History Damp State Pending
inet.0 0 0 0 0 0 0
Peer AS InPkt OutPkt OutQ Flaps Last Up/Dwn
State|#Active/Received/Accepted/Damped...
10.10.10.2 22 8559 8470 0 0 2d 16:12:56
0/0/0/0 0/0/0/0
10.10.10.6 22 8566 8468 0 0 2d 16:12:12
Copyright © 2012, Juniper Networks, Inc.