SW1000XG DataList/E - Yamaha

12 nn 10 1 00,08,09,0A OUTPUT SELECT 0:stereo out, 8:indiv1+2, 9:indiv3+4, 00
28,29,2A,2B, 10:indiv5+6,40:indiv1,41:indiv2,42:indiv3,
2C,2D 43:indiv4, 44:indiv5,45:indiv6
TOTAL SIZE 01
If data other than the above is received, 0:stereo out will be selected.
Note: In the case of OUTPUT SELECT, if the received value exceeds the number that can be supported, the parameter value will be 0.
n:Audio Part number( 0 - D )
< Table 1 - 8 >
MIDI Parameter Change table ( Audio Part Configuration )
Address Size Data Parameter Description Default value
(H) (H) (H) (H)
11 0n 00 1 00 - 01 Stereo/Monaural Switch between Stereo and Monaural 00
(Effective only for even numbered
parts)
TOTAL SIZE 01
11 0n 01 3 00 - Input Category Indicate input type,
depending on the shape of
the connector.
0:No Connection
1∼63:Connection to external device
1:Analog,others: Reserve
64∼126:Connection to internal Bus
64:PCI,others: Reserve
127:Reserve
00
00 - Input Sub Category Indicate input sub-type.
Not used at present. Set to 0.
00
00 - Input Serial Number Serial number in the same
input category.
00
TOTAL SIZE 03
n:Audio Part number( 0 - D )
< Table 1 - 9 >
MIDI Parameter Change table ( DRUM SETUP )
Address Size Data Parameter Description Default value
(H) (H) (H) (H)
3n rr 00 1 00 - 7F PITCH COARSE -64...0...+63 40
01 1 00 - 7F PITCH FINE -64...0...+63[cent] 40
02 1 00 - 7F LEVEL 0...127 depend on the note
03 1 00 - 7F ALTERNATE GROUP OFF,1...127 ″
04 1 00 - 7F PAN RND,L63...C...R63 ″
05 1 00 - 7F REVERB SEND 0...127 ″
06 1 00 - 7F CHORUS SEND 0...127 ″
07 1 00 - 7F VARIATION SEND 0...127 7F
08 1 00 - 01 KEY ASSIGN SINGLE , MULTI 00
09 1 00 - 01 Rcv NOTE OFF OFF , ON depend on the note
0A 1 00 - 01 Rcv NOTE ON OFF , ON 01
0B 1 00 - 7F LOW PASS FILTER CUTOFF FREQUENCY -64...0...63 40
0C 1 00 - 7F LOW PASS FILTER RESONANCE -64...0...63 40
0D 1 00 - 7F EG ATTACK RATE -64...0...63 40
0E 1 00 - 7F EG DECAY1 RATE -64...0...63 40
0F 1 00 - 7F EG DECAY2 RATE -64...0...63 40
TOTAL SIZE 10
3n rr 20 1 00 - 7F EQ BASS GAIN -12 - +12[dB] 40
21 1 00 - 7F EQ TREBLE GAIN -12 - +12[dB] 40
22 1 NOT USED —
23 1 NOT USED —
24 1 04 - 28 EQ BASS FREQUENCY 32...2.0k[Hz] 0C
25 1 1C - 3A EQ TREBLE FREQUENCY 500...16.0k[Hz] 36
26 1 NOT USED —
27 1 NOT USED —
28 1 NOT USED —
29 1 NOT USED —
2A 1 NOT USED —
2B 1 NOT USED —
2C 1 NOT USED —
2D 1 NOT USED —
TOTAL SIZE 0E
3n rr 40 1 00,08,09,0A OUTPUT SELECT 0:stereo out, 8:indiv1+2, 9:indiv3+4, 00
28,29,2A,2B, 10:indiv5+6,40:indiv1,41:indiv2,42:indiv3,
2C,2D 43:indiv4, 44:indiv5,45:indiv6
TOTAL SIZE 01
When data other than the above is received, 0:stereo out will be selected.
3n rr 50 1 00 - 7F HIGH PASS FILTER CUTOFF FREQUENCY -64...0...63 40
51 1 NOT USED —
TOTAL SIZE 02
3n rr 60 1 30 - 50 VELOCITY SENSE PITCH -16...0...16 depend on the note
61 1 30 - 50 VELOCITY SENSE LPF CUTOFF -16...0...16 ″
TOTAL SIZE 02
n:Drum Setup Number(0 - 3)
rr:note number(0D - 5B)
In the following cases, the SW1000XG will initialize all Drum Setups.
XG SYSTEM ON received
GM SYSTEM ON received
DRUM SETUP RESET received (when in XG mode)
81