ET-7000/PET-7000 DIO Series User Manual - ICP DAS
ET-7000/PET-7000 DIO Series User Manual - ICP DAS
ET-7000/PET-7000 DIO Series User Manual - ICP DAS
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
� LED Indicators<br />
Name LED Action Function<br />
Run Flashing Firmware is running<br />
Link/ACT<br />
10/100M<br />
Tips & Warnings<br />
� Poe LED Indicator<br />
ON Ethernet link detected<br />
OFF No Ethernet link detected<br />
Flashing Green Ethernet packet received<br />
OFF Speed 10 Mbps<br />
Orange Speed 100 Mbps<br />
If the Run LED does not display the information as above, the<br />
following steps should be taken:<br />
Step 1: Switch the power off<br />
Step 2: Check that the Init/Normal switch is in the Normal position<br />
(Refer to ―1.5.2. Back Panel‖)<br />
Step 3: Switch the power on and double-check the LED indicators<br />
When unit power is supplied via PoE (Power-over-Ethernet), the PoE indicator<br />
will be on.<br />
� Ethernet Port<br />
An Ethernet port is an opening on <strong>ET</strong>-<strong>7000</strong>/P<strong>ET</strong>-<strong>7000</strong> network equipment that<br />
Ethernet cables plug into. Ethernet ports accept cables with RJ-45 connectors.<br />
<strong>ET</strong>-<strong>7000</strong>/P<strong>ET</strong>-<strong>7000</strong> <strong>DIO</strong> <strong>Series</strong> <strong>User</strong> <strong>Manual</strong>, version 1.0.1 beta2 Page: 44<br />
Copyright © 2009 <strong>ICP</strong> <strong>DAS</strong> Co., Ltd. All Rights Reserved. E-mail: service@icpdas.com
Change language