Theben: Home & Building Control Systems KNX

SYSTEMS
MIX EXTENSIONS
MIX series actuators are extendable with a
maximum of two extension modules which
connect side by side.
MIX COMBINATION
MIX basic modules can be combined with all
MIX extension devices.
Even devices from the MIX 2 basic modules can
be combined with MIX 1 extension devices.
MIX – COST ADVANTAGES
Channel costs are reduced thanks to affordable
extension options which can have different
functions. You can achieve the right number
of channel types required for the installation.
MIX – BASE MODULES
All base modules have a BCU in which functions
are confi gured. Extension modules are
connected by side mounted plug in connections.
MIX-EXTENSION MODULES
These are connected via a side mounted plug
in connection. In the MIX 2 extension modules
the side mounted plug is retractable to ease
installation.
MIX – SHUTTER CONTROL TECHNOLOGY
Blind slats can be controlled down to the
precise degree. Close shutters or protect from
bright sunlight with awnings.
MIX- ACTUATORS
Automatic control, e.g. lighting, ventilation etc.
C-load actuators are available for especially
high lamp loads.
In addition, operating times as well as switching
currents can be monitored for Smart
Metering.
MIX- DIMMER ACTUATORS
Enable perfect light scene control or constant
light control with incandescent, halogen or
dimmable energy saving lamps.
Switch actuators
KNX
The MIX series is a group of modular DIN rail mounted devices comprising of
a base modules with optional add on extension modules. Up to two extension
modules can be connected in series to the base module. The base module is
the only part connected to the KNX bus. These extension modules can be used
to achieve low channel price. Benefit: This -ability gives you extremely high
flexibility and low system costs. -SERIES
MIX – CONTROL UNIT
In combination with electronic starter devices, it
enables the switching and dimming of lighting
circuits with fl uorescent lamps.
MIX – HEATING ACTUATORS
Room temperature can be effi ciently controlled
via thermal actuators, because the modulation
of the valve opening can be reported by the
heating boiler with the KNX interface, so that
the feed temperature can be automatically
adjusted.
MIX – INTERFACES
Binary actuators send switching statuses to
the BUS. Monitors e.g. windows and doors or
make simple, conventional sensors or switches
bus-capable.
9