ASTi Model Builder Visual Basic Training Manual Document: DOC ...

More documents

Recommendations

Info

6.7. Mapping Iris Devices ASTi MBV Telestra Training (Ver.1, Rev.B) There are two parts to mapping the hardware. First the user must setup the software side in MBV by adding Iris assets in the model. Then the user must map the Iris assets to the physical Iris devices in RMS. Figure 26: Hardware Setup and Mapping Hardware Setup and Mapping Step 1 (MBV) Assign Iris cables to Iris Assets Assets Folder “Pilot” Iris Asset Model Folder Iris Cable Iris Cable Step 2 (RMS) Map Iris Assets to Hardware devices (serial number) “Pilot” 3-xxx “Copilot” 3-yyy “Instr” 3-zzz Digital audio input and output 32 Copyright © 2006 Advanced Simulation Technology inc.
ASTi MBV Telestra Training (Ver.1, Rev.B) Iris assets in the model route audio and digital I/O to physical devices. The physical “On-Wire” Iris devices must be mapped to Iris assets in the model. Iris mapping is saved with the model in the hardware mapping file. The following instructions provide an overview on how to map Iris devices. Instructions 1. In the RMS browser, go to Hardware >>Mapping. You will see a list of Irises and quite a few “Map it” buttons. 2. Select the “Map it” button to the right of the first Iris (or any of the Irises). This will open the Iris Hardware Assignments page (shown below). 3. For each Iris component, select an Iris serial number from the pulldown list. 4. Once all components have been mapped, select the “Map Hardware” button. 5. Wait for the model to reload until the “Model is now Loaded” message is displayed. For more information on mapping Iris devices see the, ASTi Telestra 3.0 User Guide (DOC-01- TELS-UG-3), Chapter 6. Figure 27: RMS Iris Hardware Assignments Page Copyright © 2006 Advanced Simulation Technology inc. 33
Page 1: ASTi Model Builder Visual Basic Tra
Page 5 and 6: Table of Contents 1.0. Introduction
Page 7 and 8: 6.8. Configuring Model Network Sett
Page 9 and 10: 9.4. Tutorial 4- Mixer and Channel
Page 11 and 12: ASTi MBV Telestra Training (Ver.1,
Page 41: ASTi MBV Telestra Training (Ver.1,
Page 93 and 94:
ASTi MBV Telestra Training (Ver.1,
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
Page 167:
show all

ASTi Model Builder Visual Basic Training Manual Document: DOC ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?