1700AS0001 TCS Spec.pdf

7 Test Requirements
7.1 Verification cross-reference Matrix
Doc No. SALT1700AS0001 Issue A
TCS Specification
This section will indicate how system compliance to the requirements in the preceding sections will be
proven. Various types of verification (Testing, Analysis, Demonstration and Inspection) will be used at
various levels of system integration (System, Subsystem and component) as appropriate.
Para. Requirement Test
Level
[Note 1]
Test
Method
[Note 2]
Note 1: “Test Level” may be “system” (S), “subsystem” (SS) or component (C) level,
depending on the particular requirement .
Test Detail
Ref.
[Note 3]
Note 2: The "Test Method" may be any one of the following:
• Review (R) - the design is reviewed and it is obvious to all whether or not the item
complies (e.g. whether or not the system has a particular mode).
• Inspection (I) - the completed item is inspected and compliance can be easily
observed. This is normally used for physical characteristics such as colour,
dimensions and mass.
• Testing (T) - this entails a technical effort whereby the system is stimulated in a
certain fashion and its response compared to the required response.
• Analysis (A) – compliance of the design to the requirement is proved by mathematical
analysis.
Note 3: Where it is considered important, reference to the detail of the test method described
in section 7.2 is be provided in the "Details" column of the table
Table 11: Verification Cross-Reference Matrix
7.2 Detailed Test Methods
Where applicable, provide details of particular tests that will be done. (Especially for potentially
contentious requirements or critical performance criteria.)
46