Catalogue Bore machining Chapter Roughing - komet group

� 90° 90° 90° 90° 80° 90° 90°
Insert
WOEX WOEX WOEX WOEX WOEX CCMT CCMT
172 172 172 172 172 178 178
� 90° 90° 90° 90° 80° 90° 90°
x d1
WOEX CCMT CCMT TOGX WOEX CCMT TOGX
172 178 178 180 172 178 180
x d2
• Axially adjustable insert holder for constant division of cut between the two cutting
edges.
• Radially adjustable insert holder for full twin cutter effect.
• Radially adjustable insert holders allow conversion to stepped tool for
larger depth.
• Compact tool design.
• For deep roughing operations chip removal is by means of
the spiral flutes.
• With ABS connection.
• Application range from 24 to 215 mm diameter.
KOMET TwinKom® G01
Other Possible Combinations
adjustable axially + radially axially + radially axially + radially axially + radially axially + radially axially + radially axially + radially
Page
Basic body
short
long
Insert
adjustable radially axially + radially radially axially + radially radially radially axially + radially
Page
Combination roughing / Combination finishing
With combination roughing and combination finishing, division of the whole cutting width
is produced by offsetting the cutting edge axially and radially. This should allow the ensuing
cutting forces to be better distributed and produce an even cutting result.
With the roughing operation, this allows double the cutting width
(using only a single feed rate f=fz)
With the finishing operation, the cutting width is divided so that some of the intermediate
machining can be omitted.
With long chipping materials, improved chip control is achieved by means of division
between axial and radial cutting.
With long projection lengths, great operational smoothness is achieved.
169
1
2