2600 Test-A Pack System

. Press SET.
c. The prefill status automatically changes.
d. To save the change, press SET.
Resetting the Test Counter
a. Press the UP or DOWN arrow until the cursor points to #XXX, where XXX
represents a 3-digit number from #001-#999.
b. Press SET to reset the package counter to #001 if desired.
Set Creep Test Units
Figure 12
a. Press the UP or DOWN arrow until the cursor points to the UNITS field in
the right column of the Creep Test Setup screen (Figure 10).
b. Press SET. The Creep Test Units screen will appear (Figure 12).
c. Press and hold the UP or DOWN arrow until the cursor points to the desired
units of measurement.
d. Press SET. The selected unit of measurement is entered into memory, and is
displayed on the screen.
Set Creep Test Pressure Level
NOTE
The Creep Test Pressure Level must be reset whenever
the creep test pressure unit of measurement is changed.
This selection is automatic.
a. Press the UP or DOWN arrow until the cursor points to the row immediately
below the units of measurement in the right side of the Creep Test Setup
Screen.
Carleton Technologies Inc. doing business as Cobham Life Support 18