2600 Test-A Pack System

When you‟re ready to begin the test, press START. Testing will begin automatically.
Save Creep Test Results
This information will be available as hardcopy if a printer is being used. If you are using
a PC with Test-A-Pack data collection software, the test results will automatically be
stored in a user named file on the PC hard drive. If a printer or computer is unavailable,
record the information, since you‟ll use this data in your package quality analysis.
Creep-To-Burst-Dual Test
The DUAL TEST executes a standard Creep Test, followed immediately by a burst test
(Plot 3).
Pressure
T1
Before you begin Creep-to-Burst testing, you‟ll need to determine test parameters for the
type of package to be tested. The factory presets are: FLOW = 5, SENSIT = 1, PREFILL
= Y, PKG COUNTER = 001, UNITS = In.H2O, TEST PRESSURE = 20, TIME = 10
(Figure 14).
Dual Test Setup Screen
T0
Hold Time at
Pressure
Time
Plot 3
a. At the Select Mode menu, press the UP or DOWN arrow until the cursor points
to CREEP TEST.
b. Press SET. The Creep Test Type screen will appear.
T1
Pressure Increase
to Burst
Carleton Technologies Inc. doing business as Cobham Life Support 20