SFIGMOMANOMETRO DA POLSO AUTOMATICO ... - PiC solution

Clearing values from memory
Hold down the M key for around 5 seconds and the data recorded in the memory zone will be cancelled.
Press the M key for 5 seconds.
Troubleshooting
If any faults should occur during use, please check the following points.
Symptoms Control Correction
No display when the ON/OFF/
START key is pressed
EE mark shown on display or the
blood pressure value is displayed
excessively low (high)
Have the batteries run down?
Are the batteries positioned the
wrong way round?
Is the cuff placed correctly?
Did you talk or move?
Did you move with the cuff on
your wrist?
30
Replace them with new alkaline
batteries.
Re-insert the batteries in the
correct positions.
Wrap the cuff properly so that it is
positioned correctly.
Measure again calmly. Keep the
wrist steady during measurement.
notes:
1. If the unit still does not work, return it to your dealer. Under no circumstance should you disassemble
and repair the unit by yourself.
2. For a guide to the error messages that appear on the display see the instructions on page 23.
Warning
1. Check that the device is intact before using
2. The unit contains high-precision components. Therefore, avoid extreme temperatures, humidity, and
direct sunlight. Avoid dropping or shaking the main unit, and protect it from dust.
3. Clean the blood pressure monitor body and the cuff carefully with a slightly damp, soft cloth. Do not
press. Do not bend the pre-formed cuff inside out. Do not wash the cuff or use chemical cleaner on it.
Never use thinner, alcohol or petrol (gasoline) as cleaner.
4. Leaky batteries can damage the unit. Remove the batteries when the unit is not used for a long time.
5. The unit should not be operated by children so to avoid hazardous situations.
6. Do not disassemble the main unit or cuff.
7. If the unit is stored near freezing, allow it to return to room temperature before use.
8. This unit is not field serviceable. You should not use any tool to open the device nor should you attempt
to adjust anything inside the device. If you have any problems, please contact the store or the doctor
from whom you purchase this unit.
9. For users diagnosed with common arrhythmia (atrial or ventricular premature beats or atrial fibrillation),
diabetes, poor circulation of blood, kidney problems, or for users suffered from stroke or for unconscious
users, the device, as all automatic blood pressure monitors, may have difficulty in determining the proper
blood pressure. These users must consult with their doctor regularly
10. In diabetic patients with general arteriosclerosis the oscillometric measurement is negatively affected
by the hardening of the artery. So in these cases, auscultation results are more precise.
11. To stop the measurement at any time, press the ON/OFF/START key. The cuff will quickly deflate.
12. Once the inflation reaches 300 mmHg, the unit will start deflating rapidly for safety reasons.