Manual de la Soft-Starter SS W-04 Manual de la Soft ... - Dimotec
Manual de la Soft-Starter SS W-04 Manual de la Soft ... - Dimotec
Manual de la Soft-Starter SS W-04 Manual de la Soft ... - Dimotec
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
4<br />
ENERGIZACION<br />
/ PUESTA EN MARCHA<br />
4.2 ENERGIZACION<br />
Luego <strong>de</strong> <strong>la</strong> preparación para energización <strong>la</strong> <strong>Soft</strong>starter<br />
pue<strong>de</strong> ser energizada:<br />
1) Verifique <strong>la</strong> tensión <strong>de</strong> alimentación<br />
Mida <strong>la</strong> tensión <strong>de</strong> red y verifique si está <strong>de</strong>ntro<br />
<strong>de</strong>l rango permitido (tensión nominal + 10% a -<br />
15%).<br />
2) Energice <strong>la</strong> entrada y <strong>la</strong> tensión <strong>de</strong> control<br />
Cierre <strong>la</strong> seccionadora <strong>de</strong> entrada.<br />
3) Verifique el éxito <strong>de</strong> <strong>la</strong> energización<br />
El disp<strong>la</strong>y <strong>de</strong>l IHM-3P indica:<br />
La <strong>Soft</strong>-starter ejecuta algunas rutinas <strong>de</strong><br />
autodiagnóstico y si no existe ningún problema el<br />
disp<strong>la</strong>y indica:<br />
Esto significa que <strong>la</strong> <strong>Soft</strong>-starter está preparada<br />
(rdy=ready) para ser operada.<br />
4) Siga los pasos para colocación en funcionamiento<br />
Para el accionamiento A - operación por el IHM-3P,<br />
siga el ítem 4.3.2.<br />
Para el accionamiento B - operación vía bornes,<br />
siga el ítem 4.3.3.<br />
Para otras configuraciones <strong>de</strong> accionamiento que<br />
exijan alteraciones <strong>de</strong> varios parámetros<br />
(diferentes <strong>de</strong>l padrón), estudie primero el capítulo<br />
6 - <strong>de</strong>scripción <strong>de</strong>tal<strong>la</strong>da <strong>de</strong> los parámetros.<br />
4.3 PUESTA EM MARCHA<br />
Este ítem <strong>de</strong>scribe <strong>la</strong> puesta em marcha <strong>de</strong> los dos<br />
accionamientos típicos <strong>de</strong>scriptos anteriormente:<br />
Accionamiento A - operación por el IHM-3P.<br />
Accionamiento B - vía bornes.<br />
34