Manual de la Soft-Starter SS W-04 Manual de la Soft ... - Dimotec
Manual de la Soft-Starter SS W-04 Manual de la Soft ... - Dimotec
Manual de la Soft-Starter SS W-04 Manual de la Soft ... - Dimotec
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
6<br />
DESCRIPCION<br />
DETALLADA DE LOS PARAMETROS<br />
Valores posíbles<br />
Padrón<br />
Fábrica<br />
P61 - Habilita Comandos vía IHM/ Serie<br />
OFF, ON<br />
ON<br />
6.4.11 - P62 - Dirección <strong>de</strong><br />
<strong>la</strong> <strong>Soft</strong>-<strong>Starter</strong> en<br />
<strong>la</strong> red <strong>de</strong> comunicación<br />
Define <strong>la</strong> dirección que <strong>la</strong> <strong>Soft</strong>-<strong>Starter</strong> respon<strong>de</strong>rá<br />
en <strong>la</strong> red <strong>de</strong> comunicación entre todos los equipamientos<br />
que estuviesen conectados.<br />
P62 - Dirección <strong>de</strong> <strong>la</strong> <strong>Soft</strong>-<strong>Starter</strong> en <strong>la</strong><br />
red <strong>de</strong> comunicación<br />
mín. Rango máx.<br />
menor paso<br />
Padrón<br />
Fábrica<br />
1 1 30 1<br />
6.5 PARAMETROS DEL MOTOR: P21, P25, P26, P27<br />
6.5.1 P21 - Ajuste <strong>de</strong> <strong>la</strong><br />
corriente <strong>de</strong>l motor<br />
(%IN <strong>de</strong> <strong>la</strong><br />
<strong>Soft</strong>-starter)<br />
<br />
<br />
<br />
<br />
Ajustar el valor (porcentual en re<strong>la</strong>ción a <strong>la</strong> <strong>Soft</strong>starter)<br />
<strong>de</strong> <strong>la</strong> corriente <strong>de</strong>l motor.<br />
Supervisa <strong>la</strong>s condiciones <strong>de</strong> sobrecarga conforme<br />
curva <strong>de</strong> <strong>la</strong> c<strong>la</strong>se térmica seleccionada en P25 protegiendo<br />
térmicamente el motor contra sobrecargas<br />
aplicadas a su eje. Caso exceda el tiempo <strong>de</strong>finido<br />
por <strong>la</strong> C<strong>la</strong>se Protección Térmica los disparos<br />
<strong>de</strong> los tiristores son bloqueados e indica en el disp<strong>la</strong>y<br />
<strong>de</strong>l IHM-3P error E<strong>04</strong>.<br />
Hacen parte <strong>de</strong> <strong>la</strong> protección térmica los siguientes<br />
parámetros: P21, P25, P26 y P27.<br />
Para <strong>de</strong>shabilitar <strong>la</strong> protección térmica colocar<br />
P21=OFF.<br />
68