Reverb Stealth Height Adjust Seatpost User Manual - YT Industries

English7install the seatpostReverb Stealth User ManualInstall the seatpost at the desired height. Your seatpost must be inserted into the seattube a minimum of 80 mm or the minimum amount specified by your frame manufacturer;whichever is greater.Torque the seat clamp device to the frame manufacturer’slowest specification. Do not exceed 6.7 N·m (60 in-lb).Reverb Stealth User Manual9Adjust the saddle angleAdjust your saddle to the angle and fore-aft position of your preference, then use a 4mm hex to tighten each seat clamp bolt, in an alternating fashion,to 8-10 N·m (70-89 in-lb).English8WARNING - Minimum InsertionYou must install your seatpost so that theminimum required seatpost length is insidethe frame’s seat tube. Installing the seatpostwith less than the minimum length required forinsertion can cause damage to the seatpostand/or bicycle frame which can cause theseatpost and/or bicycle frame to fail, which canlead to serious injury and/or death.Install the saddle to the seatpostMake sure the saddle rails are seated in thegrooves between the top and bottom clamps.The top clamp does not need to be completelyremoved to install the saddle.≥80 mm≤6.7 N·m(≤60 in-lb)1048-10 N·m(70-89 in-lb)align the seatpost to the frameIf necessary, loosen the seat clamp device on your frame and alignyour seatpost so that the saddle is in line with the top tubeof your frame.Re-torque the seat clamp device to the frame manufacturer’sspecifications or 5-6 N·m (40-60 in-lb), whichever is lower.48-10 N·m(70-89 in-lb)8 95-4215-004-000 Rev ACopyright © 2011 SRAM, LLC9